lynall's latest activity

@tyregeezer doing some good work there and informative. Nice to see how these motors are built & repaired @gstuart keep the faith…

Hi managed to get end of cill lower wheel arch out today, very rusty will make a new piece maybe in two pieces, but can now get to innercill to release and cut out rust so one more cut and it's going back together hopefully Bit more...

Not seen that before👍

And the answer is...simple. At the foremost inlet port there is a small circular peg: Push the piston in a little to take the spring pressure off it and remove it. Relax the pressure on the piston and it pops out: And its now apart...

I think std series exhaust might be to small a diameter? Nice pipe, but 234 quid kin hell! I made my own. I had to go up because of pto shaft, early diesel also took their exhaust out the nearside inner wing.

What the jumper?? 😂 My td5 90 heats up in no time at all, in winter the cab is very toasty! (The hole at the bottom rear edge of my seat box has to be stuffed with a jumper though!!) 😆

it will just need a run for it to clear and will be fine

I counted about 15 knocks in 5 seconds that’s 180 per minute Assume tickover speed about 720rpm, so cam speed is 360rpm Does it sound noiser with ear to air intake After rebuilding my 200di I had a regular clonk like that , turned out I stuffed a...

Always worth a look at the how to videos on youtube.

The latches on all of them are rubbish, freelander/d3/d4 I think are all the same part numbers, but pls check first!

Gotta have hand throttle for the pto winch:banana: