Recent content by landyhaze

A month back I was getting my Freelander MOT'd and it failed on a split gaitor on the driveshaft, so they removed the driveshaft for the MOT (they consulted me first and I said yep, take it off then). I have been having great 'fun' disassembling the driveshaft from the VCU, which required...

Turns out it was a rear wheel cylinder went fubar, and of course the fluid made the hand brake a bit useless on one side.

Hi Nodge, Well, the light only came on after the scary moment, and I had all the brake lines replaced last year. I think you are on the right track though, since if I pump the brake pedal a lot and suddenly press it to the floor, there is a tiny, tiny bit of brake action right at the very...

While driving to work this morning, I went to use the brakes about 5 miles into my Journey, and the pedal went right to the floor. Total brake failure, no warning. Luckily I managed to stop using the handbrake, and luckily I was wearing dark brown trousers. Now I have a little red exclamation...

Has anyone got photos? my MY2004 FL1 has started having the rear brakes sieze in the morning - it used to only be if I left the handbrake on overnight, but now it happens even if I leave the car in gear over night with the handbrake off. I'm guessing there is a massive lip on the brake surface...

On the first drive with replacemnt PCB, The FBH kicked in, I set of driving, and the temperature gauge moved up to 12 o'clock position in around 5 minutes ! Amazing. 2 Hours later I started her up again for the return journey, and I started a stop watch at the same time . The temp gauge went...

OK so the PCB had died, new PCB installed by removing the wheel arch liner. While I was there I installed the Blue and Yellow wires which are needed for the remot control option. Top tip - you have to remove the pink clip in the connector body before you insert the new contact. Thread the two...

Fuel Burning Heater fan kicking in when <5 Degrees OAT ?

Hooked up the laptop for the commute home this evening - cleared the faults, but then got a new one "low supply voltage" the WTT software screen was indicating 6 or 7 volts. I guess this needs to be fixed before I do any PCB swapping. Luckily the PCB and gaskets on my spare FBH all look very...

Thanks Arctic - Hazel

I think I can get the PCB off by 'just' removing the passenger side front wheel arch liner. Can you PM me french Mike's contact details - I may just send one of my spare PCBs to him - it would be nice to have at least one thing in the equation to be known & working.

I had it running just fine on Saturday - it fired up first time after 9 months in the shed - no smoke, just worked perfectly for 29 minutes...

Interesting - The PCBs are conformally coated with laquer before the white gunk is applied. I guess it is possible at the factory they use two part silicone rather than the self-curing RTV stuff with the vinegar in - learnt something new about the corrosion. My triumph was short lived with my...

Nodge68, The white mushroom things are silicone, they put it on PCBs that are subject to extreme vibration. It stops the big blue bits from shaking themselves off.

Hi Arctic2, It just so happens I attacked the gaskets with a scalpel and stuck them back together. One with cycle glue, and the other with super-glue.I wonder which will last the best? It took me 4 hours to swap over the dead FBH for my repaired unit.I mostly spent time trying to remove the two...