Recent content by landyboots
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
L
Wow....Well done. Looks like a serious improvement to the original. Would you wire it direct through a relay to the original 2 stage switch or would you use a resistor setup with say a 4 stage switch for serious airflow when required?
-
L
Thats interesting. I must look for it on my setup. A previous owner did the double up mod on my matrix and it makes a huge difference in heat output. The problem is it just doesn't come out fast enough with the crappy blower. I've seen a few old posts on here recommending an ebay 4" bilge blower...
-
L
Cheers.....Thanks for that. Some very helpful information there :)
-
L
Hi all. Hope you are all keeping well in these most difficult times.....I have a question about my heater blower unit. With the 2 stage switch, it blows from very slowly to slowly. I'm sure it's working as designed but it's pathetic compared to the blast from my other halves Renault Megane...
-
L
Thank you..... Need to save a small fortune now. Alcohol will have to sit it out for a while ;)
-
L
Police spec on Paddocks site are showing 285.50 lbs/in :o The red/white are standard heavy duty rears and are rated at 170 lbs/in so, I think 2 sets for front and rear to cope with the extra weight of the Mazda lump.
-
L
Thank you. That helps a lot and adds clarity for the overweight diesel. :)
-
L
Thanks for that info.....Any idea what colour marks are on those police spec springs?
-
L
Thanks all....I am running a Mazda 3.5 SLTI so was thinking rear red/yellow springs on the front also to cope with the Mazda's weight.
Anyone have any thoughts or experience with this kind of extra weight on the front and how to decide which springs to use?
Thank you all again.
-
-
L
Hi all....Do any of you know the part number/colour codes for the standard OE coil springs?
I want to keep the softer ride.
Thanks all....
-
L
Thank you....When you say bonded, you mean some sort of epoxy glue I presume?
-
L
Hi all....Just wondering how easy or difficult it is to remove the bump strips on my E reg classic. I am in the process of rubbing down for paint and the bump strips are in the way for flatting the curved edge pressings behind them. One of the strips is bending away from the panel on one end and...
-
L
So it's Cellulose paint that you recommend?....
Thanks.
-
L
Thanks Bobsicle. That is really very helpful. I didn't know that Dulux trade paint and DIY paint was so different in quality. You learn something new everyday. Would you recommend a water based gloss for the top coat or something cellulose?....You obviously have great knowledge and experience...