Recent content by Land Rover Tom
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
I thinks its the nut behind the steering wheel ;lol
-
I have had a listen and seems to be coming from the gear box mount I have just had both front swivels rebuilt so should be ok Thanks .
-
-
Hi I have a series 3 and when I take my foot off the accelerator there is a cluck noise any ideas what this is coming from Thanks Tom
-
Hi my series 3 88, is quite bouncy on the front end ,or is this normal on these ,Thanks Tom
-
Thank You SOOOOO much I now have a Great pedal Cheers Mate .
-
Thank You I will report back tomorrow Cheers Regards Tom
-
Thanks mate I will try tomorrow ,does it matter which front I bleed first ! Oh yes shoes have been adjusted but will double check .
-
HI I have tried bleeding my brakes today and keep ending up with a sponge pedal which gets close to floor boards .And can anyone tell me the correct bleeding sequence I have three manuals including Haynes and they all tell me a different sequence which is not helping .Brakes are all new...
-
Thank you will defo do that Regards Tom .
-
Brilliant Steve a Great Help I will do Cheers I will report back with hopefully great progress .Bi Tom
-
Thanks Steve for help that is fantastic I was going to bleed the whole system but I thought the new master cylinder needed bleeding a well .The diagram you kindly sent me will show me exactly what to do cheers mate Best Tom
-
HI Thanks for your reply I might try without bleeding as I find it hard to get parts other than ordering online and landy has been off road for over a week now waiting for parts etc, The reservoir is connected by a pipe so there is only one more out let once Reservoir is connected?
Kind Regards Tom
-
Hi can someone please tell me how to bench bleed a new Brake master cylinder on a series 3 Landy Thanks !!
-
HI Hope I am posting this on correct thread .Can you please tell me which way around the rear hub seal goes on a series land rover is it lip towards the bearing and flat edge to stub axle or the other way round cheers