Recent content by Kilroyd
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
K
All advice is welcome, i know nothing about these cars other than researching the jobs I've done, so it's all good
-
K
Looks nice and clean under there though mate, like new.
-
K
I raised the hub up with a jack to ride height before tightening.
-
K
Lol, look at those buggers! Upgraded oil pump it is then. Thanks again for your help, im glad I found this forum
-
K
Ha, I know what you mean, they're a great bit of kit. I use mine for work (tree surgery) pulling a trailer on smaller jobs and need it to go in farmer's fields etc. It's great.
I've bought a timing belt kit from AF with all the pulleys and idlers and the aux belt, but haven't fitted yet. Got...
-
K
Fantastic, will do, thanks
-
K
Oh god that reply went a bit wrong, not sure how I managed to sandwich it into your comment...I do have a multimeter but I don't know the 1st thing about vehicle electronics so I'm not sure how far i'd get
-
-
-
K
And yes, i think it's only switching the lights off that turns them off, although I haven't actually tried turning other things off to double check, I will do.
-
K
Hi, thanks for this. I haven't yet had the wheels aligned, although I am going to, but the fault was happening before so I thought it was unrelated. That said, it happens much more frequently now and maybe the knackered wishbone was throwing it out too? I'll get the alignment done next job...
-
K
Also, I did remove the butterfly flap thing when doing the egr blank, thanks again!
-
K
Many thanks all.
The battery voltage with engine off is just 12.45V
I'll check at 2500rpm tomorrow and let you know, thank you.
I changed the front off side lower wishbone.
I'll take the shroud off as suggested, thank you. I'm ordering a new steering angle sensor to see if it helps with HDC...
-
K
I also recently blanked off the egr valve pipes and changed a front wishbone, but both hdc fault and engine not switching off predated this work.
-
K
The voltage readings were taken with the engine running on idle, didn't seem to fluctuate when I turned radio and air con and lights in etc and ran at 2000rpm