Recent content by Kieron Riley

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. K

    Engine drops revs at 3000 revs

    Hi it is 2004 and has 124000 on the clock
  2. K

    Engine drops revs at 3000 revs

    The The engine seems to cut out but if I just let the car slow down and then put my foot down again it will go again until it reaches 3000 revs and then stalls again, this will happen at any speed it’s the 3000 that stalls it, thanks for reading my post and trying to help. Kieron
  3. K

    Engine drops revs at 3000 revs

    hi my freelancer TD4 has started dropping in revs at about three thousand revs, I changed the air filter which was all but full ,and it stopped doing it for about three days but it has started again have any of you very knowledgable people any ideas as to the possible cause of this fault ...
  4. K

    noisy sounds like bearing

    thanks very much to al of you, I have had the propshaft taken off and sure enough the noise has gone how ever there is now a slight clunk on take up of power and on decelerating , I suppose this could be the front drive shaft,all help gratefully accepted . Kieron
  5. K

    noisy sounds like bearing

    thanks very much for that info, the tyres are the same size and make and age so the best ones I think will be on the back as the fronts usually wear first (I think) they are all in quite good nick, the noise is quite load but not a grinding noise .it was mot,d a few weeks ago and the inspector...
  6. K

    noisy sounds like bearing

    hi my freelander td4 has started making a noise like a wheel bearing gone, had it looked at and am told its not a wheel bearing but could be the diff which would mean a new gearbox, the front drive shaft boot is torn but there is no oil around it at gearbox end, there is oil around the rear...
Back
Top