Recent content by Kieran725
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
-
K
Today the car battery had run down. I left the lights on last night. I went to open the bonnet so I could attach the booster to get it gong but the bonnet release cable broke. How can I get into the bonnet. I am totally stuck with this one. Any advice would be greatly received.
-
K
Hi Guys.
I have just been given a Tiger parts Defender Raised air intake Can anyone tell me if It will be possible to mod it to fit a 3door freelander 02 plate TD4.
-
K
Hi there gstuart thanks for that I will try it tomorrow. :-)
-
K
I did this with mine. I filled it right to the brim with diesel and ran it through. Ove I had an almost empty light I changed the Filter put some Wyns Extrem Diesel engine clean in and filled it half way. That did the trick. :-)
-
K
Hi Guys. After lots of trying I can't get the console panel that the heater switched are behind. Try as I might it just won't budge. I have taken the screw out from the back of the Ash tray recess, the 2 screws out that hold the heater switches in and the 2 screws either side in the foot wells...
-
K
Well I have had a problem with the fuel pump and injectors today. there was a problem with low fuel pressure. Smoke the works. The Engine waning light was on and the car had lost a load of power. I thought I was going to have a very expensive day. I spoke to a mechanic friend of mine and he...
-
-
K
How about move the steering wheel up to its full Hight and a just your seat back that will solve the problem with minimum fuss. :-)
-
K
Hi Guys,
will a Vgate VS550 OBD2/EPBD-2 code reader be able to read the fault codes on my Hippo. And do you have any better fault reader ideas that won't break the bank.
The Vgate is £35
My Freelander It is an 02 plate TD4 3 door.
-
K
I will try cleaning the heater switch first. :-)
-
K
Hi Long dog I will do that.
-
K
Hi Teddywood thanks for that I will try another one. I already put a new one in. Maybe it was duff. :-/
-
K
Ok Here goes. My heater fan stopped working. So I replaced the Regulator Fuze but that didn't do the trick. I have replaced the heater fan and now it works on setting 4 but 1, 2 and 3 don't work. Any ideas I am now a bit confused as to what to do next.
You collective expertise is needed...
-
K
I have replaced the Drop Links and out on a new silencer.