Recent content by Jw1233

I'm having very similar issues with my disco 2 10p td5. I changed the fuel filter yesterday evening and purged the air out of it about 8 times and then took it for a quick drive which everything seemed fine but the car would not start this morning. I'm thinking there must be air still in the...

I just checked the injectors and all the numbers match up but the last letter of every number is A but on the nanocom it says M

Thankyou i will try this, but car has original ecu, would the tuning chip be able to change the injector settings?

Yes i can do that, how do i check the injector codes? Cheers

Hi i'm having a couple issues after fitting a new remap chip to an msb ecu in a 10p td5, to begin with i had a remap chip which was fitted by the guy who had the car before but it struggled to get past 3,000rpm and felt underpowered. So i bought a new chip from boottune with a rev limiter that...

Nice one cheers

Oh okay so the first thing i need to do is code my key into the bcu then? Would i need the code for this or can i just pair it via the reciever in the roof?

Okay thanks for help i try to find one with eka code, but when i do get one how should i go about pairing it with my ecu?

Yes i fitted the bcu a while ago and tried to start the car with it, it wouldn't start so i left it until i got a nanocom and then tried to start again today which is when i ran into these problems, do you think that it is telling me it can't communicate with the ecu just because of the bcu then?

Cheers i had to save up for a nanocom, got it the other day although i'm pretty useless with it, i've plugged it in with the new(second hand) bcu and i'm basically locked out of everything because the ecu is immobilised although it learns security code with no issue but it won't give me any...

Sweet thanks for help

So a nanocom would definitely do it then?

Thanks mate i have a icarsoft code reader which might do the job as it has a land rover setting

Hi the bcu got some water inside it and i have got a crossed b flashing on the lcd display and a beep coming from the dash and the hazards lights or indicators aren't working and the engine won't turn over, so i have ordered a new bcu for the car however i'm wondering if it's just as simple as...

Same thing is going on with my one(1999 disco 2) if i were to buy a new bcu would it need coding in or can i just whack any one in there, cheers