Recent content by [email protected]

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. J

    1995 4.6 hse over heating ???????

    thanks the only think i won t do is the top liners. thanks for your help again this bloody is costing now. not so cheap
  2. J

    1995 4.6 hse over heating ???????

    thanks for every ones help, i am going to order a new rad , because i still think if it was a liner shift or cracked block it would show up some where in the test i have done, and if block is cream cracker ed, i new rad would be a good idea any way, is there any reason if i get top hat liners...
  3. J

    1995 4.6 hse over heating ???????

    thanks again for reply.i hope the block is ok after all that bloody work to do head gaskets . as its past all test so far you would think liners ,block are fine. but water pipes do go solid with pressure and when water in red it just blows water out of cap. i am going to buy a sniff test. the...
  4. J

    1995 4.6 hse over heating ???????

    thank you , seams new rad might be needed, and some engine sealer/
  5. J

    1995 4.6 hse over heating ???????

    hi i have a 4.6 hse which i have just brought with a over heating problem, so fitted new head gaskets skimmed heads, new thermostat, water system flashed through, compression tested 145 psi on all 8 and all held that psi for at least 10 min s , no bubbles in header tank. water pressure tested no...
  6. J

    p38 dse engine keeps stalling

    hi thanks for replying was it a major job to change pump. did it need setting on a lap top after. where can i get info on timing and locking pin before i remove also do you think i could just get mine repaired. if so would you no of company who could do it. thanks jeremy
  7. J

    p38 dse engine keeps stalling

    hi i have a range rover 1998 dse. which you can be driving along all is fine but as you lift of the gas pedal the motor just dies and then about two seconds later it jumps back in to live. it also cuts out when try to park. ie going from drive to revs. but then you can start straight away. any...
Back
Top