Recent content by jimmyjoe
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
I am restoring a series 2a I purchased engine and gearbox mounts from paddocks two are fat and less height and the other two are of a smaller diameter but higher can anyone tell which are the engine and which are the gearbox because :confused: I have forgot ?
-
thanks for the link they only seam to do seals no electrical bits
-
i am restoring a series 2a land rover and need to get some new brushes for the Lucas wiper motors has anyone found a good suppler?
-
i am in the middle of changing a chassis on my series II the rear springs have broken spring clips and bolts does anyone know if these can be obtained ?
-
thanks what back number is it?
-
i am going to do a NEW galvanised chassis change on my 1963 series II a does anyone have any advise or help?:)
-
no just difficulty to select first bit sloppy
-
it is a sreis II a 88 inch hard top
-
-
i am going to buy some replacement door tops from paddocks i see they do channel kits is there anything else i need?
-
sorry spotted mistake it should be feeling lol
-
there is no spring felling next to first is this a box strip ?
-
dificulty selecting first or reverse on my series II is there a detent or is it hit or miss?
-
-
hi this is my first post i have been welding for a long time and i am just about to try to get a old series II through its mot could anyone advise a good source for bits? it needs some Chassis work and the door slides need replacing also needs new sliding glass bits:)