Recent content by jamesd2009
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
J
did you chekc the high pressure sensor on the fuel rail. my one was constantly bouncing on and off power and turned out the connectors had a load of green on them.cleaned it and job done
-
J
another thing to check when i get home.thanks for that. i'm just hoping its not vcu/ird related
-
J
Cheers man .No vibration in the steering.I'll check the prop.thanks
-
J
Hi all
I was driving my mums FL1 TD4 and when you get up to speed theres a droning noise that gets louder and quieter. If you accelerate it stops but if you keep it at speed it just gets louder and quieter in a rhythm. Only very slight vibration.Barely noticed it.Its a 2006 with 70k km on it...
-
J
thanks.i hope this solves it. i know my diff mounts are knackered too so they're getting replaced aswell.Gareth,what else owuld cause that clicking so?
-
J
Thanks for that .thought the diff or vcu was the culprit .driving me mad
-
J
I have to replace the whole prop section don't I ?couldn't see a bolt to remove it
-
J
Would that account for the clicking im hearing
-
J
http://m.youtube.com/watch?v=mCXz9POrgk4
Hopefully this will work
-
J
I took a video on my phone but not sure how to upload it
-
J
I took the prop off when the clicking started .prop off noise gone so inspected it .it's definitely the joint moving a bit side to side .would that be the cause and is that joint now knackered
-
J
Hi all
Should there be any play in the joint that bolts from the prop to the diff (the one with 4 bolts)?
I have the usual up down motion but have a few mm side to side play .
And also would that play account for a clicking im hearing from near the rear that increases /decreases with speed ...
-
J
take the plug off the high pressure sensor and give it a clean with contact cleaner.plug it in and out a few times and see if that works. mine was juddering like crzy for a while.changed everything and it turned out to be that
-
J
hi all. so while i was away the mechanic took off the propshaft and all is quiet now. so is the likely cause bearings?the vcu wouldn't tap if it was fialling would it?
Thanks
-
J
i'll get him to check that.thanks