Recent content by james1992

Yeah i am getting abit white smoke didnt know if it was just the cold. Hmm i have never checked the glow plugs actually Thanks

Okay will get some parts ordered today and see what happens hopefully this will solve the problem as if i dont get it sorted it will be getting sold for something jap

Thanks for that i will start checking things over and sèe what i find as it hasnt been serviced since september so i will order a service kit asap and get that done too. How hard are the injector looms to replace?

Yeah it seems too never had this sort of problem before. It sometimes makes a grindy noise and doesnt engage but 2nd turn of the key it does but this happens. The problem doesnt occur when warm only first start up after not being started to engine is cold

Hi where abouts are you as i am intrested in your alloys?

Hi everyone when i have been going to start my discovery the last week or so it seems as though the engine is seized or something is sticking as when the engine turn s over it starts but is vibrating and shaking the car as it does it and then it goes normal and runs sort of fine. Anyone have...

Yeah its seems like it might be the centre bush thats gone so mught retighten and see whats happens with the knock

I fitted them about september time i think

Hi i have them in my watts linkage seem okay but unsure if they will last a long time as i think i have a knock starting on the linkage again

Possibly but i need it put on diagnostics to find out what fault codes is there. The fault started with a overboost fault which kept happening at 3000rpm. I spoke to alive tuning down at peterborough lro show and they said it would be the boost modulator and to take it off and connect the 2...

Hi does anybody know a good land rover independent specialist around durham/ tyne and wear as i have a few faults on my td5 disco and just want it put right asap as its my daily? Cheers

I have to agree after i rang the person who fitted the clutch that he isnt sure if he checked it when he put it in but he presumes it went back in the correct way so have had a couple of people i know take a look at it and they all say clutch plate wrong way

We made sure the clutch plate was the right way as it had flywheel sixe wrote on

It starts jerking when i try it in gear with foot on clutch whilst turning engine on

Yeah everything worked properley before. The box went in fine does the spigot bush stop clutch working even though the box went straight back in easy enough