Recent content by James Rogers

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. James Rogers

    P38A Eas issue

    Could you possibly email me, [email protected]. Thanks.
  2. James Rogers

    P38A Eas issue

    Thanks
  3. James Rogers

    P38A Eas issue

    That's what I thought. I have a local dealer I use. Can they run the diagnostics?
  4. James Rogers

    P38A Eas issue

    I've read a few and I think maybe height sensor issue but would like your advice. Drove somewhere yesterday, all fine. Then again today for 6 miles or so, all fine. Then I didn't look at suspension but noticed that about 5/6 more miles the suspension was on wade mode and normal level was...
  5. James Rogers

    P38A Head gasket?

    Yh i meant spark plugs, sorry should have specified.
  6. James Rogers

    P38A Head gasket?

    Take the plugs out?
  7. James Rogers

    P38A P38 heater matrix o ring and eas

    Swapped out the diaphragm seal and it's sorted it, didn't even need a new compressor in the end so thanks for the help. I did, whilst waiting fit an online valve to the pipe that goes to the tank and bought a tyre inflater with the self level relay out at night. This proved that my suspension...
  8. James Rogers

    P38A Head gasket?

    I've had a search on here and haven't had much luck... My dad's p38 (4.6 thor) has an issue. He rang me to say that he's stopped and water was leaking past the cap and that the cap was loose. So he tightened the cap and the temp gauge went up but then back down again. So I said, once it's...
  9. James Rogers

    P38A P38 heater matrix o ring and eas

    Sorry, wasn't clear. I meant I pumped it up using my compressor in the workshop. The compressor on the car won't pump it above about 30!!
  10. James Rogers

    P38A P38 heater matrix o ring and eas

    I have 2 anyway, both duffs but one slightly less duff. I'll await Kurt's reply and then do up one of the two I have and maybe sell one.
  11. James Rogers

    P38A P38 heater matrix o ring and eas

    What would you suggest? Buy one off Kurt or recon one myself? And is the liner important or not?
  12. James Rogers

    P38A P38 heater matrix o ring and eas

    OK awesome would like a kit with a liner too, or are they not an issue?
  13. James Rogers

    P38A P38 heater matrix o ring and eas

    Yh it did, but the pressure coming out doesn't feel a lot, is it a good idea to rebuild the compressor myself or buy a new one?
  14. James Rogers

    P38A P38 heater matrix o ring and eas

    Just done some investigating and I think it could be a duff compressor. I put a manual valve in line with pipe 6, pumped it up to 110psi (most I could get from my compressor) compressor is constantly running. I can just about block off the air coming from it too. The little silencer on the valve...
  15. James Rogers

    P38A P38 heater matrix o ring and eas

    Funny you should say that... Upon trying to start my car the last couple of days it say engine disabled, but I think the battery on my keys has had it, would that cause this? If I lock and unlock the car manually it starts fine. Is it dead battery in key or the leak? I'll do it next week
Back
Top