Recent content by IandiscoV8

Just read tour last post. I have similar issue it will not stay at ride height overnight. Needs calibrating

You could also try jacking the corner up, do not go too far just get the sensor moving and it may send a signal?

Have you tried cleaning the connector blocks with contact cleaner, worked with my off side rear sensor. If this does not work try a decent make one, I have genuine on the rear and copy front, fronts took ages to settle down. I still need to calibrate all 4 of them.

Hi Steve, Are you saying car is not recognising the part not communicating with it?

I bit the bullet and ripped - carefully removed the dash out last weekend and installed my new genuine Blend motors and the heating is working perfectly. No book symbol - first for me on a P38 DO NOT connect the blend motors before installing them !! Dash board top front panels are not a...

Height sensors have been changed front and rear Mark, i have only eyeballed it and inputted figures into Nanocom, It is 'doing the dance' when I switch off and start up, as my car is a rolling resto daily driver and other things have got in the way of calibration job - the boss would say...

Hi all, Update on my Suspension. Everything is working OK but... I think there is a leak drivers side front, I have not replaced the air springs yet. Rear air springs replaced and has transformed ride quailty. The car is driving perfectly fine with no suspension faults, I think air compressor is...

Hi Mark, I checked every where, the car was so cheap I did not even check, I checked it was on the slam panel and thats it! Passed MOT with no issues or advisories - which surprised me. I am not overly worried. Going to double check the chassis leg this evening. Ian

Hi All, been a while. I have been fixing up my 2002 4.6 V8 Vogue. While fixing the blend motors I took the dash out. When I replaced the dash top I have noticed the bukhead/windscreen VIN plate is missing. Previous owner had a new windscreen fitted and I am thinking it got cut off when...

Not keen on the L322. The bumper crash bar is completely rotted out, side mounts rotted and its held on with cable ties

Also another update! New front left sensor not working on wading heaight. Also the car going down far enough after 24 hours to go into a hard fault - so must still have a leak somewhere Onward

Grrrrrr, Haha nothing behind my rear plastic cover on the 2002 Vogue. Also on the CVC its equally poor and gone to the scrap man! I will find a proper one for CVC one - not so fussed about my 2002 Vogue.

14th built, chassis 129 def genuine CVC factory vehicle. It has development notes all over it, wings where they mount are different for instance. Interior seats are wrong, wheels are wrong, obs has wrong tailgate and someone decided to paint it Black. There is evidence of original Epsom green.

LR development vehicle - did not word that very well

My development prototype 14th built On the way to my house How I found her