Recent content by @Hoveedge
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
@
Thanks for the advice on both matters. Front shocks seem ok it just sits low at the back when towing. No leaks but feels bouncy.
-
@
Hi im after some advise. I have several creaking noises on my td4 majority front end. I'm putting it down to 139000 miles and thinking of changing shocks and all bushes ect round suspension just to give it an overhaul as not sure when any of them been changed. Any recommedations welcome and...
-
@
Hi I have started finding it difficult to engage 1st gear. Really stiff to engage and got to really push it in. Had new clutch, slave and master cylinders fitted last year. Does clutch need blessing again?
-
-
@
Did my EGR valve mod at the weekend. Three cans of oven cleaner 1st can left over night. Could not believe the gunk that came out of the air box. Put all back together. Engine sounds better, sharper acceleration at low revs. Biggest thing I've noticed is fuel is lasting ages. Put 20 quid in...
-
@
Hi how much delivered to Brighouse HD6 2LX
-
@
Do you have rear passenger door window regulator both sides
-
@
Anyone traveling from Wigan to Brighouse need some kitchen unit doors bringing down
-
@
My HER seems really bloody tight into it' exhaust breather should it be if so what trick do you do to release
-
@
At last, what a struggle this has been but finally with the help of this site I have removed the tuning chip box and wiring loom. The chip was wired into the rail pressure sensor fortunatey the original plug was still on so it was an easy removal. Refitted boost sensor which has always been...
-
@
Hi going to strip it down tomorrow, so will report back and put full details on.
-
@
Hi I have opened the grey box
I opened the grey tuning box up this morning inside is a very wet circuit board, it is covered in protective wax but I suspect water is the devil. Photos of inside gubbins attached. I'm very nervous about playing about with the settings, as i know little about...
-
@
I have messaged the eBay seller asking for an email of fitting instructions so I can then work backwards and remove this pile of ****e.
-
@
Hi thanks for the reply this is the exact unit and harness I have fitted on mine https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.co.uk%2Fulk%2Fitm%2F202099697435
It is plugged into the fuel rail sensor and I believe the MAF sensor. The harnes on the link is exact to mine.
-
@
Hi got home and started car which I had running yesterday. Today hard to start lumpy and loads of black smoke followed by white smoke. It then died and would not start when it did it was only for seconds. Unplugged grey box. Car started straght away but engine management light stayed on and...