GrumpyGel's latest activity

My old F1 came home for a repair ‘visit’ today. Needed a new rear light lens fitting 🙄

So after a couple of weeks procrastinating I finally made time to try and figure out how to make the charger work at a commercial EVSE which the setup above failed to achieve. It works great at home but commercial chargers require a low...

A few years since the last post, and this is my first, but thought it might come in handy. Fitted a reverse camera and screen to my FL2 today. Wasn't keen on removing the boot door liner, partly laziness, and partly didn't trust the plastic clips...

I know it is an old post this but I’ve been having the same issue for the last 3 weeks and was about to buy a new fob and get it programmed Tried this and it works great 👍🏻

Didn’t notice that at the time… both front sensors have 0 DC, but both rears have ~2.4… 🤔 Maybe try Nodge’s suggestion with a multimeter on the fronts first

1.7kph when stationary is normal. I think that this is the "slowest" speed that it can sense. The diagnostic protocol gets cut off above a certain speed, for "health and safety" reasons. The ABS is not actually functioning when the diagnostic...

I'm pretty sure the Amigo lamps on the dash are powered by wires coming from the Wabco ecu... So if they are lit, it is because these pins have been powered by the Wabco ecu. Strange there are no error codes in it. When HDC is selected, the...

Before you think it's wrong pads, check the calipers are working properly and not seized

That's not a lot of play.

Rears; 302mm diameter Thickness new 12mm Thickness at service limit 10mm Max runout 0.08mm

Thought i would post an update as I've made progress. On another recent thread someone posted that the air intake temperature sensor works in tandem with the MAP sensor, and I can confirm that if you just replace the temperature sensor without...

Nah, I'll help a Cantabrian to pay for his kids school shoes rather than give money to a Chinese iron works. I should think the rears do a lot less work than the fronts and will last a long time anyway. Anyone know the original and minimum...

Thanks, that's what I was expecting to see! Think I'll have to get the disks skimmed and a new set of pads. Hope it hasn't knackered the calipers.

Excuse my ignorance, I've not delved into how the brakes work on the F2. But does the handbrake operate on the calipers/pads or are there not shoes inside the disc/drum/hub jobbie that it would apply?

So I've had my F2 over a year now. Its been running lovely, the only imperfection being squeaky brakes. When I got it, it had just had new brakes fitted, so thought it was probably just bedding in. Roll on a year and they are still 'bedding...

Are you on commission, cos its probably been listed for years that one...

Hi everyone! While I was busy with locating the "fuse" problem, I happened to find another problem and was able to fix it! From the beginning, my Freelander with the L-Series diesel was not exactly a rocket. I had no comparison and took it as it...

I have a Bambulabs X1c and it is excellent. The AMS allows it to print up to 4 colour models. Baby Groots anyone? The milwaukee box was printed too.