Recent content by freelandermad
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
F
Fusebox looks fine.... i did notice one dry solder on the PCB after i dismantled the whole lot back to the PCB...board looked a bit discoloured on the relay point that seems to control the
HEVAC (i think) (yellow relay very bottom driver side corner of fusebox) so done a continuity test, the...
-
F
Hiya guys....more problems than I anticipated. Took it upto mike aitken at ladybank today and seems like I may have fusebox wiring corrosion so that's what I'm off to do right now....his diagnostics which is the right RR/LR stuff isn't reading the ecu etc and can defo smell fusebox electrical...
-
F
Sent them a message thanks for info :-)
-
F
Yeah ive took it out the underpanel & checked it..all connections are intact gave each wire a good wee tug
-
F
lol...honestly its doing ma head in....
no idle, cables soldered up properly.... am actually thinking its laptop n i need XP with a serial port
I've tried it via a prolific usb serial.... chipset is a fake pl2303 so cant get driver for it
and desktop is running windows 8
-
F
Comms problem.... hows bout :censored::censored::censored::censored: blowing up thing with a large :censored: box of matches!!!
Cable all wired fine.... nothing different in the RX....apart from 28 / 80 codes
Totally baffled now!
-
F
Yeah probably I'll update how i get on tomorrow with it... might fit the 19" screen into dash while am at it tomorrow save humphing the whole lot into RR again lol :D
-
F
Well no that am trying to look silly but..... there is a video on youtube of RSW showing that the EAS unlock will still run without it being connected to the car...hence why i posted up the screenshot of it running without being on the car & also a screenshot of faults without it being in the...
-
F
Yeah its not connected in the car wammers.... just got it plugged into old desktop the now
-
F
right a wee screen shot.... managed to get the cable recognised on an old desktop.... but have a look at the RX part.... its not connected upto RR yet...just cable whapped into the port etc
-
F
humpHing it.... :censored: lol
-
F
I did read instructions...hence why i said i changed com ports etc....
Its my laptop that isnt allowing it to be used...it works fine on desktop both tx & rx....
looks like i'll have to humph desktop out to RR :mad:
-
F
ok... cable done
connected up to laptop..... initialize and starts going 1. 2. 3. 4 then so on 1. FF in the TX screen
but the RX is saying PP....
tried it a few times now and still saying PP
Any ideas?
-
F
255 x 60 x 18
Yeah a bit but i shall adjust according to manual
-
F
Maybe let 'some' air out then lol..... i'm in scotland...free dental care :-)