Recent content by Elltee

Ive since found out that its a 'sheet motor for a tipper' I'll call/email superwinch at some point and see if i can get some proper details from them soon

Awesome. Time to buy :)

It's an Lt77. So the diff lock linkage is compatible. And come through the trans tunnel in the same position?

Wanting to put in a disco t/box

Sorry. Currently 1985 90, Disco 300tdi, defender gearbox and transfer with disco rear axle - as I understand from the previous owner

I've seen all the posts for pros and cons, but what is actually required to fit it. Prop length? Gear and diff gear stick positions? Gearbox out? Any internal mods required? Speedo issues? Cheers

Breather blocked causing it to build pressure?

I've just been given a superwinch motor and gearbox new. Still in the box. I think was spare for a recovery truck but can I make use of it? Info: Motor - 12v dc Gearbox - 03703 On the box truck windlass 6011 12v dc 3703

Hmm... Thanks I'm doing everything I can not to take it back out again

Unfortunately not. I wasn't in the best mood as the old box broke on the way home the day I bought it and just wanted the job done. The transfer box came with it turned fine and I had to turn the that over to get the input shaft splines to line up with the clutch. So I'm assuming it rotates OK...

I've fitted a second hand gear box after swapping the linkage clutch fork and slave over from my old box. Gear stick won't move forward or back but it will slide left and right and I can feel the notch for reverse. But again. Still won't go forward. I'm away from the car now but could the...

Sounds like I've got the right idea for everything else I've read. Do you think it would be an advantage to do it over a pit?

Disco 300tdi on defender lt77 box and disco rear axle

That's good to hear. Im planning on using a crane like you say but thought it would have to go through the seat box. I got the floor and tunnel off this afternoon before work but had to shoot off before I really took in what I could get at from there. Does the handbrake get in the way? Good...

So I've bought a shed... I've got a new gearbox to fit as the plug full out bringing her home, draining all the oil and then was slipping in every gear. So I've started out by trying to remove the seats and seat box to find that the seats have been nut and bolted so they're just spinning once...