Recent content by Dutch389

It is this joint. The small ball joint at the end if the upper wishbone suspension arm. Looking at parts it looks like the arm and joint are sold as a preassembled unit.

Thats great advice. I dont minde Nyone saying anything if it gets the job done. I have a 90 degree air drill and some dremel discs. Also I was thinking of using a nut splitter. I have to buy the koint so I have a bit of time. I'll let you al know how I get on.

When you say give it a whack. From top?

The thread is turning with the nut

Hi. Need help. The upper front left ball joint nut won't undo. The whole thread simply spins. I need to drop the upright to replace the stub axle prop shaft. Inner boot has split. Phil

Maybe, when I pulled the cable, I didn't pull it enough. I know I pulled it with some ease but recent articles have said it needs some significant effort. Perhaps that what I need to do, pull the release, separate the elements which will allow me to wind the mechanism back. then I can...

Hey, thanks but that thread is where this all started, i found it and it prompted me to join the Disco Forum despite me have a RRSport TDV6 2.7. OK so the when I look at my EPB internals I see something different. I see the brass rod all the way to the right but the white unit (on the left of...

Thanks for your help. So, i did pull the release cable some months back, I have only just got around to this, MoT coming up. I stripped the rear LHS last night, looks like ir was waded in a past life, quite the horror story. I have adjusted the shoes but the EPB is on its travel limit. (FYI...

Can anyone help? I found a thread on here where the EPB could be reset on the car, with difficulty, by removing the lid on the unit above the Diff. After some travail, rust bolts, rusty screws and the like, I have the lid off. I cannot find the thread with the instructions on how to wind the...