Recent content by Dibdabdom
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
Hi All
injector seals replaced now and have started her up seems fine, only driven around the block will have a good run out tomorrow
looking at the pic of the seals they needed doing so fingers cross .:)
Big thank you to everyone on here
Dom
-
Thank for reply will see how it goes:D
-
Hi Sierrafery
Thanks for reply iam using this as a step by step which is very helpful
I havent yet replaced the seals or removed rocker shaft and was looking at how its set now and looks as if no1 is not at highest point when i line up timing mark
When i replace and go to setting each injector...
-
Hi Guys
Can anyone help iam trying to fit seals today and have turn engine to marks on timing chain but the no1 rocker isn't set at highest point?
was wondering if iam missing sometime as never done this before and dont want to mess up, i can see the timing pin slot from above
ive turned engine...
-
Thanks sierrafery
I have read that this common fault after 100,000 miles as with injector harness . thinking now to do injectors first then tank out to check pipes after if not resolved
cant see any fuel leaks anywhere (unless its very small hole somewhere ).
Car only seems to get air in...
-
Cheers Neilly will look at all these vids
going to have a good look around fuel pump and pipes along chassis tomorrow , then new injector washers and o rings
never done this before but found some how to on the web, just need fan spanner and torque wrench
Do you know if its possible to...
-
Thank you for quick reply will do :)
-
Hi
This is my first post but have been very grateful to Landyzone for loads of help on the car reading other peoples how to's etc..
Wondering if someone can point me on what to do next !!
Have a air in fuel problem :mad:
Changed injector harness and clean out red plug regularly ( now no oil at...
-