Recent content by Devo

Went for a 300km+ drive on corrugated dirt roads last Sunday and both front windows have stopped working. So far I have; Placed a meter across the fuse for the front windows and have power there. Replaced the front window relay. Removed door trim L/H and checked for power. None there...

my EU3 TD5 Disco won't start. Ran it out of fuel as the gauge does not read right. purged the fuel system as per workshop manual. Turns over but it won't start. Pump is working, I can hear it. I loosened the fuel filter and it is pumping heaps of fuel. If I have flooded it what can I do...

have been away with no internet connection. Thanks ot all for the replies. Sounds as if my TD5 is in the ball park.

Can any of you blokes tell me what sort of fuel consumption I should be getting out of my 2004Td5Disco. I have just replaced the fuel pressure regulator at the back of the head as it was leaking fuel out of the rear plug. I have a slight surge down low that I didn't notice before. I am...

Thanks for the advise. I have run the purge cycle several times and have run it. All good. The engine is running perfectly again. Thanks ever so much for your help, Devo

IGP50, Thanks for the reply. It was a 60/40 mix. I took out the fuel pump and mopped out the tank after draining the tank. I havehad the fuel regulator off and cleaned out as much of the petrol as possible. What a job!! Devo

Hi all, My 2004Disco Td5 has been filled with petrol, 60L of 100L tank. Unbeknown to me I drove for 12km before parking it up as it was not running right and I noticed the fuel pump was noisy. Parked up and have drained the tank and replaced the filter. Can anyone tell me what damage may...

Thanks for the advice. Disconected battery terminal and tacked successfully. Only problem is, now that I am up and running again disconecting the battery must have upset the locking circuit. Now I have no remote locking. It seems to have been turned off. Does anyone know if I can turn it on...

Needing help again! I need to tac weld with a mig, a section of pipe into where I have removed the cat converter. Is there a problem welding on a disco when the battery is disconected? Is there a problem disconecting the battery? Does the computer need resetting afterwards? Regards, Graeme

It is indeed against the law here to tamper with any anti-polution components however, as has been advised,if the guts mysteriously disapears out of the cat-converter then with out tampering then that is ok. I took your advice and established that the non-genuine is $900 AUS and the genuine is...

I have a rattle in the silencer in the front pipe. The exhaust centre advises me it is not a silencer but an Exhaust Gas Purifier similar to a Catylitic Converter on a petrol. I have been told the front pipe is $900 AUS. Genuine. Is there anyone in Australia who can advise on a cheaper...

Had heaps of trouble for 12 months with my air springs. Never leaked when I checked with soap but if I turned my back they went down. In the finish it was the bags. The layers of rubber part with wear and leak intermittently till they finally fail. Be aware that the problem will burn out a...

After lots of investigation I have finally found the problem. The left hand rear bag has now got a leak that is not intermittent. I am desparate to find an after market self leveling airspring supplier in australia who is not a thief. The prices for original here are breathtaking. Any...

Thanks for the advice. I will investigate further and let you know for future reference what I come up with. Cheers Urban Panzer

Hi All, I have a Disco IIs 2004. When I park up with the suspension in normal height, the suspension drops to low. It takes less time to drop now than a week ago. If I park up with suspension in raised (elevated) position the suspension stays up. There seems to be no abnormal action from...