Recent content by davec18

yes no probs not sure what tm p& p will be email may be quicker [email protected]

drivers door

yes have 1 that I took off my 2000 discovery 2 £35.00+

I have for sale 2 exhaust manifolds for a v8 these have been ceramic coated in silver offers over £50 the pair email me @ [email protected] for further info

the long path to owning a older d2 td5 long learning curve

shame your so far away you could have used mine or I could have helped you solve the problem

check that the interior light is working and going out when you close the doors you could check it with a volt meter as well ?? best thing that I have bought for my landy is the nano com expensive but in the long run worth it

HI had a similar problem with mine changed most things even the filter nsr behind the lamp unit , rebuilt the compressor etc then when I was going through nano com I saw that drivers door lock had intermittent fault checked wiring and changed the lock assy been ok since ? just a thought for you...

chers but was hoping to repair the old 1 ?? will have to put up with just 3 & 4 then

Hi can any one tell me why I cant find a replacement heater resistor pack to fit my 2000 td5 it is a block of what looks like ceramic on the inside and I cant see how to fix it ?? I wanted to upload a pic but the site wont let me ?

turned out to be both just my luck still it is a land rover . got that sorted so did a service on the old girl now it wont start , My son who also drives it said he has not heard the fuel pump running lately so going to change that as well now perhaps that will also cure the surging . never...

Eventually found the problem it is / was the 13 pin connector on the ABS block where the loom turns tight onto the block sorted been ok for 2 weeks now

many thanks sierrafery will check when it stops raining ???

Yes understand that had it before I changed all wheel sensors all bearings ok if it was sensors or wheel bearing then why can I sometimes drive for a week or so without any signs of 3 amigos or with 1 handbrake light on

Hi I have a disco 2 2000 and have a problem with electrics not my favourite thing I get a fault code with my nano com Ecu ground fault or reference ground fault . I have done all the ground terminals that I can find inc the block behind the left side kick panel and all the ones in the engine...