Recent content by dannyboy 270781

You neglect to say whether it is manual or automatic? The reason i ask is that many auto gearbox faults are very simular to that which you describe. The problem is not forced to be engine related.

Hello, just wandering if any other freelander 2 owners have had problems with clutch judder? I have with my 07 reg 2.2 TD4 which i brought from new. 8 months down the line i started to notice what can only be described as clutch judder when pulling hard in 3rd or 4th gear right in the power...

Thanks Sean, i'll get the flange first and try it on the shaft. :)

If the switch is open then no power can reach the consumer. It's a good idea to remember that the switch does not carry load, if it did it would soon burn out. It mearly switches the relay. The relay supplys the current demanded by the consumer (in this case the spot lamps) from the battery...

Hello, i seem to have a simular problem, although the oil seems to be traveling down the spline of the half shaft and then leaking from the rubber cap on the end of the hub. There is a little wear between the flange and half shaft and headache in the bearing which i am going to try and adjust...

I had the same problem with my 51 reg freelander. The "spongyness" or lack of pedal is caused by air entering the hydralic system. This normally enters at the seals in either the master or slave cylinder. When my pedal started to go i blead the system. This cured it for a few days. "Back...

Hello, my name is Dan. I own a freelander 2 and a landrover 90. The freelander is a couple of years old and i've had it from new. I had an original freelander before that and have recently purchased my landrover 90. Sort of just landed on it really. I wasn't out looking for one. My wife...