Recent content by Dancernbc

datatek, more info, if i switch both heated seats on, fault on fuse 2 still shows on startup and switch off. thou the fault warning is not repeated whilst driving, again switch of heated seats and warning returns every few minutes. question, is fuse box the issue, or could it be an issue...

Sorry if I have double tapped yopu with this message P38, Showing a warning that fuser 2 (heated seats) is blown, thou on inspection fuse is ok. this fuse also covers the rear right window , which works fine. any idears how to clear message, have tried differnt fuse

Thanks datatek, i will give rick the pick a pm. thanks again

i take it there is someone on here who can fix, sort the BECM issues. Is there a reset process for the BECM

ps, have hade the heater matrix seals changed

was a little damp, however nothing to bad,

my error, sorry, its a p38 2001.\ Sorry for any confussion

P38, Showing a warning that fuser 2 (heated seats) is blown, thou on inspection fuse is ok. this fuse also covers the rear right window , which works fine. any idears how to clear message, have tried differnt fuse

hi, can i ask, and a question, keep getting warning that fuse 2 (heated seats and left rear window) is blown, thou fuse is ok

hello, Just found my heater matrix appeares to have failed on my right hand drive 2001 p38. In our post you said you can remove the matrix without removing the dash or steering coloum. Any advice you could give would be most kind, hoping I can change this without taking the dash out...

hi, if the item is still availabile would you be able to fit (at a price) regards

Paul, Hi there, just rounded of the heater matrix screw so it on with the drilling then. Can you confirm if you achieved this without taking the dash out, also what size and type of drill did you use. Any additional info would be greatly apperaited. Regards Graeme

Hi, I have the same issue, thought its the passangers sides thatys cold. Althought I can change the flow of cold air from floor to vets to screen. Having discussed this with a number of poeple they say it is more likley to be the HVAC playing up. Thoughts anyone.

To further my questions will a coolant flush help prevent this again once heads changed fixed

Hi there after a bit of advice. Took p38 4.6 to get LPG serviced all going well. All done vehicle cranking not starting then it happened, coolant starts posing out of Heather tank. So heads of later this week, question is new heads possible, however would you recommend changing radiator...