Recent content by Daly17

Thanks for all the help. I've tried the ebay link but it says that the page is missing. So I'll just use the jubilee clips for now.

I recently fitted new lower suspension arms, drop links Caliper carriers, calipers, arb bushes, prop uj's discs, pads and a clutch to my 2005 td4.Now 2 months later my arb has slid to the side and was rubbing the bottom of the strut. I repositioned it and it happened again. I got a new set of...

Iy turned out to be a badly routed vacuum pipe which had a hole burnt through it. Seems to be OK though now, apart from a fault code, P1613. That comes up as engine stability fault. Do you know what that is please.

It has the Synergy 2 fitted to it. Although I have no Idea how to set it up correctly. No instructions and the ones I can download are as clear as mud.

:):):):)

It has a brand new pierburg maf sensor. There was some discussion about the right part no for the maf. Their book suggested one that looked nothing like the one I took out, the part number for the one I removed they claim is for a mercedes. So I fitted the one with the same part number as the...

My mechanic mate scanned it and it came up with a faulty maf sensor. Replaced it but it made no difference. The fbh never worked before i did my clutch. Strange that, is that why the heater matrix hoses get so hot.

Recently I changed my clutch on a 2.0 td4 Freelander 1. I had to remove the inlet manifold to do it. After reassembly it is very lumpy on tickover and has no throttle response at all, foot to the floor and nothing happens. Also after only a couple of minutes, the heater pipes are red hot. There...

Thank you. Have you any idea what may be wrong with my car. Have posted it up. Tia

Thanks for letting me join. I live in France near limoges. Got a very poorly freelander 1 at the moment. Looking forward to tapping you all up for your expertise and knowledge. Regards Bernard 17

I recently replaced the clutch on my freelander 1, 2 litre td4. As part of the job I had to remove the inlet manifold. After the job was done I put the inlet manifold back & reconnected everything. The engine is now very lumpy on tickler and even with the throttle flat on the floor it won't rev...