Recent content by chris100e

2010 freelander 2 L359, when key fob is inserted the hazards come on and the central locking clicks. The engine will start but stops after a few seconds

still not running, I assume that the srs problem is the reason. Fount the 4 crash sensors and tested they all give the same reading 26m oms and 2.6m oms in the other direction. Maybe I should get the srs module tested and cleared of errors

for some time now have had the srs light on, but still able to drive. Then the seat belt warning started when driving it was suggested that I use contact cleaner on the belt holder but its not that simple as it does not seem to be a straight micro switch. Today checking all fuses on all three...

Freelander 2 2010 air bag light on using my topdon 800bt fault codeB00D 5_12 and also B10A2_00. I can clear the B00D but it returns When restarting car. The B00D does not clear. I know the codes relate to passenger restraint disable and crash input I have tested all air bags 2.2 ohms so they...

this has just started to happen driver side seatbelt warning works as it should but i get a second seatbelt warning come on it has the seatbelt sign but with a dot beside it.Its on all the time. I have tried the normal things but cant clear it

Any modifications/removal to emissions related devices, this includes DPF'S and EGR's is now a major fail. above is part of the new MOT from may 2018 will put my erg kit on ebay !!!

I will have to look up what the new mot requires but I thought they only checked nox gases which the erg does not effect

kit I have must remove all traces of it, think I will change it for the type that leaves most in situ.

I have purchased a egr boost gauge removal blanking bypass kit. It came with no fitting instructions. the kit contains new housing to replace the egr valve/stop cap/blanking plate //two metal disks. the new housing has a small tube welded to its side. I assume this can be used for a boost...

have had a good look at them, the tip of the bleed nipple only shows about 2mm on the outside of the backing plate. You cant get a spanner on it, with the drum removed the cylinder is about 3mm away from the backing plate. On the bottom of the cylinder its against the backing plate. Also you can...

Servo and master cylinder replaced, but when bleeding brakes , front ok but rear could not get too bleed nipple on either side,removed drum and found wheel cylinder at an angle to the back plate . Could not remove as badly corroded. Need to get new cylinders and a big hammer. btw: on inspecting...

well the uckfield train is still as bad,

A lot of the above I don,t yet understand. But have now removed the rear drive shaft, came off in two bits ? fitted new one just need to replace the servo then road test. Only had the freelander for three months and so far have replaced front wiper motor/rear heated screen and rear brakes. All...

Taking into account members reply's, when its stops raining will have another check. It sounds like cv joint as the sound is at road speed

i will give it a go later as its tipping it down at the moment, thanks