Recent content by C13tay1

105k miles Mot till November Recent Yokohama all terrains Recent silicone inter cooler hoses BMW PCV filter EGR bypass Genuine soft nudge Genuine fog pods Tow bar just fitted... Electrics not connected Side steps Roof rack Drivers side rear window needs new reg Drivers side mirror doesn't...

Never done it so can't be sure but everything I've read about it would indicate that you have to drop subframe Chris

On principal I would take it back to garage ...... A slave cylinder should be expected to last more than 18 months. If the garage fitted it incorrectly or chose to use a cheap pattern part this is their fault Even if you have decided to get rid.... Get the garage to sort this first then at...

Found a hole in my intercooler pipe..a bracket has rubbed right through it !!!! Bugger

Rocking horse ...... Hens teeth....... Holy grail Gave up on one of those years ago Just got a genuine land rover one cheap off eBay..... Currently modifying it so that its full length Just have to figure out best way of mounting it in roof rail mounting points to get it close to roof...

Re painted my interior door handles using ford champagne gold ..... Look ok and much better than the old scratched version

When I did mine..... Ground all the rivets down ..... Gave the ball joint a whack with the hammer and off it came

Thanks for the replies I'll have another look tomorrow On my previous freelanders it was loose , just there Chris

did all freelanders come with pre installed tow electrics ? On my last 3 freelanders I've had no trouble finding the connector... Took of the drivers side panel in the boot and there lurking around was a white connector. Just fitted a tow bar to my 2004 SE, took the panel off and can't find...

Cables are cheap A complete regulator and motor can be had for about 30 quid or so........ Pattern part but with 2 year warranty

At my last oil change I used the latest spec ll04 Stuff It's way to thin for me .... My engine seems a lot noisier than it was before As said above this is probably great in a brand new engine but not right in an older engine with over 100k on the clock Will be going for a cheaper semi...

You can get ready made up cables from eBay. I used some a while ago and they were fine Chris

+1

ThAnks openfold Hadn't thought about that Chris

That's good ..... Looking at the mangled bit of metal I got out of there I don't think welding it back in is an option I'll live without it .... Or might see if I can bolt it in if there is enough clearance when the door is shut Chris