Recent content by Borimur

I fixed them, thanks for listening!

Cheers guys, I worked it out and they're working perfectly. Ben.

Yes, a long wet trip!! Thanks heaps toxsox. The switches are 5 pin and they are in the centre console, where the little coin box was. Ben.

Well if I knew what an ECU was I would tell you Peter! They are 5 pin switches and I have the wiring. I need to know how to wire the switch leads and the power, earth ect together in the proper order. Thanks heaps Peter, Ben.

I appreciate the offer toxie but I think Berwick in Victoria, Australia is a bit of a stretch!! If you know something about electrics, maybe you can help me with a diagram of the power window looming from the 2 console (5 pin) switches to the power source and to the 2 door wires? I had a little...

:doh:Hello, has anybody changed the dash cluster in a 92' manual 3.5 ltr V8, 2 door Discovery? It is probably cable driven and I have a selection of newer Disco's to replace the cluster with. Am I mad or is there a possibllity that I may succeed? Much obliged, Ben.

Hi Peter, thanks for responding, again. I did not explain my problem correctly, sorry but the wiring diagram is for the 2 electric window wiring looms to go from the switches to the power source, then to the door wires under the dash. Forgive me my lazy post!!! Cheers, Benjamin.

Thank you Lister man but I needed the diagram for the electric window wiring from the switches in the centre console (2) to the power source and to the wiring underdash to the doors. Inside the doors is fine. Thanks again.:o

I am in dire need of a diagram showing the wiring from the switch looms to the power source, then to the door windows. It's for a 92' 2 door Discovery. Thanks guys. Ben

:o Dearest people, I am in need of an electric window wiring diagram for my 1992, 2 door Discovery. I need the diagram and or advise as to how I rewire the system from the central switches to the fusebox and to the doors. I thank you whole heartedly for your help.:o:o

Thanks guys, have done that although there is still a couple of inches of play at the top! I only have about 3/4 pedal pressure.

All set to bleed. How is it done properly? I am having trouble regaining pressure. And thank you for your response!

I'm having trouble regaining pressure in my pedal. Can someone please explain the correct method for bleeding the clutch cylinder? There is spring left in the pedal and the fluid is pumped through the pipe though it is slow and weak.

ps, we had a lister motor for our vineyard pump and it was brilliant, never missed a beat!

Hi Peter, thank you for responding. The clutch feels as though it doesn't have enough pressure and the gears (mainly second and fourth) crunch when pedal is fully pressed.