Recent content by Billy-g

i did have a split vacuum hose and i am sure that it was causing me issues, thanks for the heads up on the MAP. the landy has been sat on the drive while i wait for the time to get busy again (and the weather!) but fuel filter and MAP are two good places to get going on. I will post results...

arch pump seems strong, and had been replaced at about 105k (preventative) fuel filter was at the same time. hoses all look good (and at least two of them are new!) fuel filter tomorrow then?

took the landy out again today, and it is still doing it. a couple of times though, it just did not build any revs at all with my foot all the way to the floor, the only way that i could get it going was to wang up the revs and ride the clutch, just no low end power. once it was going it was...

did anyone get a fix on this? Glad to see that i am not the first!

Any help with this would be greatly appreciated Lots of knock and smoke when giving it full throttle that clears above 2.5kish Cheers

Deffo still doing it.... Any pointers welcome!

Right- tested and suddenly lacking in my confidence. She is pulling better though! What linkage did you lubricate?

Right on john, Split hose off of the what i believe is that actuator! Wish i had read yer post earlier as i was a while looking! I had the car from PZ to liskeard and sure that it could not be serious as the car was still pulling at ninety. Removes all sensors I could think of and had a...

Vacum solenoid- easy to get at?

First place im looking! Cheers Ratty!

I have done the bmw mod before so it shouldnt be blocked- should it?

Not this time! My instinct says it is somethIng niggly as it is fine at full speed. It went into a limp mode yesterday, will that have logged a fault code?

Not this time! My instinct says it is somethIng niggly as it is fine at full speed. It went into a limp mode yesterday, will that have logged a fault code?

Hi all, long time no visit and that was all good for me! 130k on the clock and I have just started on a high load engine problem. Starting is a bit crap again too. Getting going is sluggish if not reluctant, and when you try giving it a bit of boot to get going more often than than not...

mines been knocking for a couple of years, 120K on the clock, pulling strong. I have gotten to the point where I just don't worry anymore...