Recent content by bentonrover
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
B
Meter read 0 ohms. Is there a seperate harness for the rear sensors?
-
B
Is it possible that both rear wheel sensors fail together? Still tracing the abs/tc faults. Metered the front sensors and they read 1000 ohms the rear 0. How? Is there a separate harness? Tried everything and keep throwing money into it. Lights came on months ago and stayed ever since. Brakes...
-
B
oh ok how about little heat from a torch.
-
-
B
Hey for the guys that done this mod post pics. Here on the states no one seems to know about this. Thanks
-
B
Cool thanks so is a pry bar needed. Cause these things are seated good
-
B
Can these be serviced without pulling the hub on a 99 p38 bosch. Trying take down a rough road code. Think its one of the sensors. Thanks
-
B
Not going into any gears is usually brake light switch. Look behind brake pedal. There is a switch attached to a bracket with a push button on it. Some times the button get stuck. Make sure that it is still connected. Check the wire connection also. Hell unplug it then replug it. Might just work.
-
B
Hey guys little confused about the whole thing here. I have a 99 bosch and it seems to do the same thing. Was this so called clicking thing only up to mid year 99 or did it extend into later years with the 4 wheel tc. Read lights and got a wheel sensor code. I'll start there and check back. Thanks
-
B
Hey been having the same issue with the click and pedal pushing back on my foot. Who have a photo of these washers and gaskets. I work for the railroad in the U.S and can probably source out a few bits. Thanks
-
B
Got a problem that I cant figure out here in the states. When leaving my 99 bosch p38 I lose power when I open the door. I try to turn the key and nothing. I get power back when I slam the door shut. Either door driver/passenger. Looked all around and cant find loose wires/connections...