bentonrover
New Member
- Posts
- 11
Can these be serviced without pulling the hub on a 99 p38 bosch. Trying take down a rough road code. Think its one of the sensors. Thanks
front abs wheel sensors?
- Thread starter bentonrover
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
eightinavee
Well-Known Member
- Posts
- 3,956
- Location
- UK.
Yes.
bentonrover
New Member
- Posts
- 11
Cool thanks so is a pry bar needed. Cause these things are seated good
eightinavee
Well-Known Member
- Posts
- 3,956
- Location
- UK.
Yes,a pry bar of some kind will be needed.The sensor must be corroded in place,be careful though they are easy to damage.I had one in from a local garage just last week where they had ruined the sensor - I had to sell them another one.
bentonrover
New Member
- Posts
- 11
oh ok how about little heat from a torch.
Irishrover
Well-Known Member
- Posts
- 5,317
- Location
- La Trimouille, Vienne, France
NO !!That will do the inside of the sensor no good at all
