Recent content by Ausman123

Thankyou I managed to unlink it from the overdrive side it was covered in so much crap I didn't spot the split pin link much appreciated

I took off my overdrive today can anyone tell me if this looks worn ? I have no diagrams as to what this should look like but my overdrive is squealing Thankyou Nick

Wonder can anyone help here I removed the farey overdive today and I enclose a picture ( it is dramatically magnified ) of a shard of metal found inside the hole of the overdrive as pictured below its difficult to see inside the hole where the overdrive came out of but can someone tell me how...

Hi all I am Trying to remove the farey overdrive for a service this may sound stupid but the bolt on the overdive lever ( does it turn clock wise or anti clockwise this bolt will not budge ) tried a snap on breaker bar still wint move ? I did notice behind it there is a split pin connection but...

I have 2 buckets under mine at the moment I know now it's only under pressure is when it leaks oil so I am presuming crank seal ( I do know the oil filter case is leaking but that was my fault ) your all obviously aware but there is a UV supplement you can add to the engine or gearbox oil which...

No I haven't Moggytom very much appreciated I will googe how far they are Wales is bigger then I thought it was when I moved here

I didn't check the earth's properly only for tightness but I can say no screeches or squeals ? No sound of a slippage type ( missing teeth on the flywheel ) the earth strap from the starter to the chassis is a bare woven mesh type cable which does look a bit twisted and old I will try a straight...

I know sweated it all the way no AA or RAC recovery hell of a risk took some basic tools but she made it as regards the tools etc I am sure there are some guys on here been through the same thing my motto now is Wife is replaceable but vehicles and tools are not lol

Yes I am beginning to see that .I have owned VW buses including a 65 VW splitscreen but the ex got it through the divorce along with a great selection of Snap on tools for the lucky new guy lol but I read the landrover can't be used daily I actually disagree as you said allot of work which I...

Sorry to trouble you again what do I have to remove to get access to fit the wading plug I am presuming propshaft etc ? Thanks again Just to also add I have a slow starter sometimes it's quick then it's slow ? I pulled the starter apart it has 4 bushes all looked OK ( what a job to get it back...

Thanks Steve that's really useful firstly no I didn't drive far with it on I will ask my Mrs to take a picture of the overdive top and you will see the silicone ( white dot someone has put there ) do you know where I can get the wading plug from ? I am buying most of my stuff from ebay regards...

Thanks guys I am slightly confused with the plug on the housing .The filter I replaced has a long bolt running through the cannister I didn't know the bolt had a seal as the filter I bought of ebay didn't come with a seal for that bolt only the round one you slot into a groove which I am sure I...

I actually looked at the part that had oil on it ( there are 2 leaks) it's the flywheel housing that's dripping oddly I found a post you put up about doing it in situ but couldn't open the link that you gave someone so I think it's the crank seal and the oil filter nit sealed properly many...