Recent content by andyf

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. A

    Clonking window

    It could either be: Windows not set, try winding windows up and down to there full extent a few times untill the car is happy and the warning stops. or The window actuator bars are worn out, this is pretty common on older cars, the bars are made of pressed steel and the geared teeth that...
  2. A

    2.5DSE, To chip or not to chip!

    Not sure if you have seen my info about the psi powerbox? I would just say be very carefull if you get one. I found it all too easy after I fitted mine to see off 4.6's etc but then popped the cylinder head, the straight 6 has a very long head and the higher pressures in the cylinders can lift...
  3. A

    running hot

    Aparantly, the old rad is just the rad, the new one has a combined oil cooler for the auto box, you just dont need to use it if you have a separate cooler in the NSF wheelarch. (I was told it is the same part no for the auto and the manual) Mine was definately the fan, as the temp went up or...
  4. A

    RR 1997 2.5 DSE - Advise please

    I'd check all switches work and put the vehicle under high load (uphill and slow speed), see the problems i had with overheating in the forum, as it can be expensive to repair just about anything on the engine...
  5. A

    P38 being broken?

    Does anyone know of any P38s being broken up (pref in the southwest), I need some trim items, a rear n/s door lock inc c/l motor and other bits and pieces..
  6. A

    running hot

    Nearly forgot, once the rad is out of the way you can then undo the bolts at the bottom or get a mini hacksaw in to cut them off and replace them, (try greasing them before refitting just in case you need to remove it again sometime). The original rad part no was superceeded so I wonder if they...
  7. A

    running hot

    Well, I took the rad out to get it re-cored, but, the bolts holding it in at the bottom were rusted, I used a drimmel to make a groove so the rad would slide up but due to a lack of clearence i cracked the lower tank while removing it (it catches on the thermo fan hub). I was quoted £130 +vat...
  8. A

    running hot

    I have just bought a 99 2.5 DSE and while going up a steep hill the other day it overheated, I have found out the electric fans are only for the aircon and hardley ever run and the P38 RR has a problem with radiators "sludging up". I filled it with water (after it blew it out the headder tank)...
Back
Top