Recent content by andrew bould

Hello, I am looking for some advice on getting the upper and lower balljoints replaced on the front of my 4.6 V8 P38, obviously this involves removing the hub and all the associated bit n bobs. Not a job i would relish doing DIY, so a trip the the garage to get the work done. I am based near...

Working through a job list on my p38 - 1997 Range Rover p38 4.6 v8 HSE

Fault traced to a faulty height sensor on rear offside, it looks like the sensor failed/broke when the car was jacked up for changing tyres. Sensor replaced and is is now well again. I used CSG Automotive in Macclesfield to fit the new sensor, apparently when the height sensor is at full scale...

Thank you for the reply I will checkout the settings via the diagnostic tool again, the message I had when trying to change height using the diag tool was "height setting inhibited" "Car lift jack switch" message screen shots attached, I will have another's go later this week, also an...

Thank you for the tips I will check the tyre pressures and abs sensors, may be fitting the new front discs disturbed the sensors

Hello all, I am new to the forum and had my RR L322 for a few months, just had new front discs and pads fitted and new all weather tyres fitted all round, also had new front air shocks in September, vehicle is all standard no modifications. Just after the brakes and tyres were fitted I drove...