Recent content by alchemist2

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. A

    disco 2 roof rack

    hi all, I want to put a roof rack on my 02 disco she has two sunroofs and it will be used for camping and carrying the odd few lenghts of timber.. what type/make of rack will suit and roughly what cost thanks in advance
  2. A

    leak

    Hi whilst checking for leaks on the turbo related pipes(down on power big time) i notice one of the linkages on the drivers side was wet the one almost underneath the starter anyhoo its connected to what appears to be a cylinder or something, higher up and this is where the weep is coming...
  3. A

    i dont know

    Thanks Dave, robbin bastids.. should be locked up with the bankers i say:mad:.. anyhoo i think the leak is comin from the pressure valvejust above the cooler.. will take a closer look tomorrow let you know how i get on:).. and you are most right theres a great group of ppl on here like yourself...
  4. A

    i dont know

    am located in ireland... and the garages charge 110 euro plus the vat an hour to look at a disco so hence me askin bout a diagnostics tool prob cheaper in the long run... the fuel cooler is the cylindrical type i had a prob when i first got the disco three yrs ago with it so the garage replaced...
  5. A

    i dont know

    yes ratty pump is still noisey.. not sure if all air is out i know there is a self bleed but where is the best place to check for bubbles if im not sure? i put a new filter on when i replaced the pump cause i got a new sedimentor when i ordered the pump... checked ecu its fine no oil at all...
  6. A

    i dont know

    its a non genuine pump... although i bought it from a landrover parts dealer in Matlock... the fuel cooler(little aluminium cylinder was replaced a few yrs ago on it as it was leaking diesel but havent had any probs since).. :confused:
  7. A

    i dont know

    hi ratty checked the pipes goin to the pump and i have em on the correct way.... changed the oil and filters as it needed it took her for a 5 mile spin and man alive fuel filter is tooooo hot to touch and a funny smell of burnin comin from the rear of the disco:(:confused:... oh and whilst...
  8. A

    i dont know

    Thanks ratty will check that out in a few hrs time:D
  9. A

    i dont know

    i have fitted a new pump not an original by the way... so i got lift off after the pump runs fine i can hear it then stops i turn her over and i can hear the pump still runnin in the cab(didnt hear that with the old one when it was working)... i drove it for 1 mile and the fuel filter is...
  10. A

    i dont know

    HI dave/ratty... i checked the plug going to the fuel tank pump for current got 12/13 volts then checked the pins on the pump for continuity got nothin... took said pump from tank looks ok no broken wires etc... gauze was ok no dirt?? but when its still not running when i try to start her up the...
  11. A

    i dont know

    heres where i am changed the fuel filter and im not gettin a delivery of fuel to the filter now have checked relays all seem fine no lights comin up on the dash though so is it the fuel pump.... normally i can hear the fuel flowin to the filter be4 ignition but no noise now?
  12. A

    i dont know

    thanks ratty and dave i will check it out tomorrow morning and let you know how i get on:)
  13. A

    i dont know

    yes ratty its a TD5 but excuse my ignorance i know what an injectoe is but whats the loom?
  14. A

    i dont know

    hi all, today my 02 disco started behaving rather strangely... driving along next thing it was like chugga chugga then it was fine then same thing happened and was again fine as i came to a hill at 50mph she started dying so i pulled over switched it off and got it up me ar.e to start it took me...
  15. A

    disco2 window regulator

    Thanks lads, the gear on the old reg broke clean off and was lying on the bottom of the door... just took a guess at where the motor and new reg meshed and bingo worked first time... managed to fit new one in without having to take out the glass too :-) as some work instructions said i would...
Back
Top