Recent content by adrianhartopp

I put new wiper blades on front and back and now I fully appreciate the song by Johnny Nash :cool::cool::cool:

I have an AP200 as well and find it does everything I need it to

Undersealed my FL2 with LanoGuard after having a recon rear diff fitted.

Autel Maxi AP200

I did the calibration as part of the fitting process, I didn't drive it until I'd finished.

Fitted a new throttle body and did the air flow calibration, before it went into the garage to have a replacement rear diff (from Bell Engineering) fitted. Massive difference to how it drives now, so much smoother and lot less noise.

£36, a large bag of Haribo TangFastic and a leek signed by the Welsh Rugby Team :D

You've got quite the knack for this. How empty is your order book? :D

And at the weekends you can call me Mandy............................🙎‍♀️

I've had a stage 1 remap done on my 08 Td4 and am pleased with the outcome. Slightly better fuel economy but more impressed with torque at lower revs. The only thing I was warned about was the gearbox not being able to handle higher torque, especially in 1st gear, so I'm always mindful to change...

I'm not at all envious...........................

I thought you were joking!!

Wow, that's far too shiny for a Land Rover!!!!

FWIW, I bought my FL2, 08 plate, HSE, Manual with 82k on the clock for £5,200. FSH, belt and water pump changed, new clutch ( inc DMF) in 2023. Immaculate condition inside and out. Since then I've had a full service on it, including all drive train oils and brake fluid changed, and that cost me...

Want to replace my handbrake gaiter as it's wearing out. I can get the frame unclipped from the rear housing but I'm at a loss of how to get it off the handbrake itself. Is it the same as the Discovery 2 in that a good, firm twist of the handle unsticks it then you can slide the whole lot off...