Recent content by Abigail096

Have been searching across many different avenues including a lot of the facebook sites in Australia without success. Thanks for the heads up on another couple of avenues to follow up on. Without the correct pulley I'll have to re-drill the holes on a standard pulley and then make up a...

Can't change the mounting piece on the pump shaft because it needs to match up to the front fan propeller shaft fittings.

The FC has the narrow belt crank pulley and S! fan hole spacings are even not offset. Have checked the 6 cylinder pulley and although pretty much the same has different hole offsets again. Photo of another one of my babies 1955 S1 that I've had for the last 51 years. Still gets to do some work...

Nothing like a sharp eye. The S1 in the background is a 1950 80". All original running gear, side plate 1.6lt motor and most of is bits are stamped 1949. Chassis Number 06104559. Water pump can be repaired and the parts are available it's just the issue with the front pulley.

It's not a standard fitting. Hole spacings are at 1 1/2 and 1 7/8 as against standard ones that are 1 1/2 either way, As it needs to bolt up to the fan propeller shaft which has the same placement I need the correct pulley. This is a rebuild that was just a pile of bits in crates that I got from...

I'm looking for help to find a water pump pulley for a S2a 4cyl Forward Control part #541156. It's a cast pulley #3 and is only suitable for the FC model. Any help would be appreciated.

The 2B FC I've acquired doesn't have any headlights in place. Must have been sold off in the past but the opening is bigger that the standard land rover head lamp assembly. It is the same as your first picture.

Sam, Did you have any joy on finding this part or an equivalent replacement item. I've also got a 2B FC that I need 2 of them for.