Recent content by 4x4forks
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
-
4
Well After No Help! I changed the air flow metre for a cheep ebay special and off she go,s again.:) The figures from the old maf unit where ok when stationary but was failing under load.
-
4
Hi All, 2004 disco auto has started hunting around 2500rpm. Done all the usual checks. Injector loom cleaned MAP sensor, Turbo waste gate free hoses all good . No faults logged . I am running out of ideas. Can anyone help please
-
-
4
Hi All . Latest problem ............. Auto box has started to hunting in 3rd gear. I can Have put in drive or pull back to 3rd and under light throttle it seems to hunt as though it was trying to change up another gear. i have changed the oil and filter twice recently as it was slow for...
-
4
Check the air sensor in the inlet manifold. If it gets dirty and oily the ecu will be getting duff info.
-
4
Hi All Disco2 Auto 54plate. Havn,t had it long when the Auto box started faulting.
Flashing M and S lights on dash and limp home mode .
Read all the threads about the subject and checked everything over. Battery and alternator on the top line. Bought a new XY switch and thought I had fixed it...
-
4
That,s just the info I was looking for. It sounds as if it is all working ok I,m just not used to the change.
-
4
Hi All. I,ve just bought a low milage 2004 td5 auto and having never owned an automatic before I was wondering at what speed the gears are surposed to change up at . It seems to me to be abit slow at changing up and seems to select 4th at just over 50mph. You also have to almost lift your foot...
-
4
I've pulled the pipe off the servo and I am getting some suck!! but i am unsure if it is enough vacuum. How much should i get ?
-
4
Just had a drive and my high milage disco, was going well but i braked going down a hill and i felt the pedal and it was hard. The next time was ok then braking at a junction it was very hard as if i had no servo!!
Question is has anyone had to change a vacum pump? if so how do i test and what...
-
4
Is your oil level increasing in the sump because it sounds to me like injector seals . This would cause the pump noise , extra fuel cumsumption and smoke. Plus I wouldn't trust what your mecanic is saying if he is telling you your injectors need adjusting or have been adjusted. The only...
-
4
Have finished job now> I have replaced the hub assembly and hub o ring as I don't like going in twice. On stipping down I have found that the "locking, seal compound had broken down. The book says put a 3mm band of sealent round the half shaft. I have towed the caravan and done about 1000 mile...
-
4
Couldn't find any mention of sealent in works manuel but checked haynes and they mention sealent. Just ordered new hub and "lock and seal" liquid.
-
4
So it is a new hub assembly for me then.
-
4
Looked at diagram of hus assembly and can't see any seal in it.