Asking again, did you hear from Rob? I, in your situation, would try and see if you can find at least one Disco1 or early Disco2 light and see if you can make it fit. You'd maybe have to fab up or obtain light surround etc, but if it gets you a...
Morning guys,
So, over the weekend someone tried to break into my disco, they tried to prize the lock then tried to prize the doors damaging the door panels on the drivers side, only found out as the dog was barking.
Absolutely fuming :mad: as...
Finally after 5 years Ive managed to take a VNT TD5 around Marquenterre and its nothing short of incredible.
Near limitless power and torque on tap when i need it. No huge run ups, no flooring it and snatching 3rd. Just driving up, mostly with...
Hi,
I have found these headlamps in Turkey question is will it fit my Right hand drive disco 2004 landmark. And will it have the correct beam pattern for the French contrôle technique?
Part number XBC501510 it says for left hand drive vehicles...
Has anyone ever had the one way valve in their ABS pump fail?
Since i got my P38, when the ABS pump is not running it would make a very soft rythmic ticking. So making an edjucated guess i thought it was the one way valve that was leaking and...
It the clutch is slightly dragging then there is always some 'spin' going on but the 1st and 2nd layshafts spin the fastest, so it's more noticable.
3rd is only slightly faster and 4th spins the same as the engine with 5th being slower than the...
Well i'm still waiting for Berger Camping and Yodel to work out who has my parcel...
However i did manage to find the correct relay and test the 'fans on without ignition' approach. Basically you inject 12 volts on the output pin (87) of the...
'89 .. the last of the 3.5's then.
Unusual to have carbs (assuming that's what you mean by the term naturally aspirated) as EFI was introduced in Oct '85, though carb variants were still available until the 3.9 was introduced near the end of that...
Up on stands even in gear wheels will still turn because diffs will be doing their thing.
It will not go into gear because the clutch is not working. As pedal is not going down there is a good chance the problem is with the clutch master...
Puma set up from Audiophile In Car
Stinger Heigh 10 front end with wireless Apple Car Play
Focal Speakers Front & Rear
Audioson 1140w DPS amp
JL Audio 6 inch Sub
All brand new and boxed
Available October
WhatsApp me on +44 7887 631 062 for more...
Morning All. :D
A damp day so far with a light misty rain.
I have nadgered meself somehow. Right knee, left arm and my neck...all sore. I hate getting old, but it is still better than the alternative. ;)
Have a great day!
Thinking of upgrading my house alarm to Texecom Premier Elite 24 because it has an optional interface allowing you to connect yer alarm to wifi or ethernet. A phone app can be used to remotely set, unset and monitor the alarm via the internet. I...
If you are using the compression fittings drill..
Is there room to drill another hole in it & use a bulkhead fitting(allows the nylon fuel pipe through & then locks off) right angle out the tank & away you go…
You can do the above on a 90 tank...
So shop keepers have to change the way thay do thing's to accommodate shop lifters ( thieves ) !! Could not make that up , but good shoes are expensive now so the police are cutting back on the amount of re-soleing thay do
If any doubts with the dpf itself, it should be removed, tested and cleaned professionally.
It is a consumable item unfortunately and at expense.
A few things to bare in mind with a dpf.
They can crack inside due to blockages and overheating...
I have a 2015, RR Vogue 3 litre which I have owned for about 18 months. No issues until this May when the 'exhaust filter full contact dealer' red warning light came on and the car went into limp mode. Took it to my local independent LR garage...
So, this weekend I tried to get my series 2a going down the road. But I couldn’t get it in gear. I had it on 4 Jack stands. Put it in gear, which it seemed to go, and the wheels didn’t drive. They were still free wheeling (I could turn them by...
Impressive stuff. I occasionally have to design EV charging installations at work so I am quite interested in what installs are good (or not) and often chat to owners to find out their experiences. I'm told that some chargers can be a bit iffy...
Rear springs both done now and shocks replaced! I just need to find a new nut for one sides top mounting as I stripped one.
Also just wondering what springs it looks like I removed? They look a little thicker so heavy duty? The new ones I've...