After I installed I ran the car for 10 mins with the door open and still didn't rise , I took that off and I could feel air put my finger on the port it made a bit of suction.
So one out of three was actually an SUV?
Well done!
and of course the BMW you mentioned is exactly like a RR, same weight, 4 wheel drive etc etc.
Yep your apples still do look much like oranges to me.
So you "got me" on the Mercedes M class...
I did not get ideas, I got insults.
But when I did get ideas I responded to the ideas with facts and I got told that I was an idiot without any mechanical knowledge.
You will never understand that but it is OK because we are now on 19 pages of...
Take the little exhaust filter out & check if there's air from the port while pump is running. If there is, then the diaphragm valve is leaking. That valve is on the same 12V that the pump uses, so it should engage together with the pump...
@Blob thanks for these. The horn diagram would seem to be correct, however the washer shows 2 x relay but the car shows on 1 x washer relay suggesting that this may not be correct?
Clearly you are rather over sensitive to anything contrary to what you think you know. Most of the comments early in this thread were why it might not be a good idea. You took them as direct critisim rather than answer in a technical manner...
Don't you understand that I'm not actually having a logical discussion with you as to whether you work for somebody or not?
I am just responding to a personal direct insult that said that because I am self-employed I must be a horrible person...
I have just checked the relay operation for these two items (going by the top of the fuse/relay cover in engine bay) and the horn relay operates suggesting a dead horn - need to get hold of one (eBay here I come)
The washer relay doesn't...
Haaaaaaaa!!!
Yes my 23 year old Range Rover is uniquely different to BMWs from the same era even though they are using BMW running gear!
Even though the engine in his BMW is a higher displacement version of my actual engine, and his car is from...
I have just replaced the compressor in my P38 after it recently dropped to the bump stops , it still will not rise and the new compressor is very hot. It's not a hard fault as I have no lights on the dash and the eas switch doesn't have all 4...
Just in case anyone is sufficiently MASO to want to read his piffle on the other forum:
https://www.rangerovers.net/threads/my-crazy-diff-ratio-change-idea.370261/
Except I have said so many times here that I am not towing and I am not putting a roof rack on and it will just be me and my dogs.
So for my situation it is a great idea, which I explained in the other forum.
So you ignored my explanation in...
I do not need to post pictures of differentials here that I can see have identical mounting points to then have other people here tell me that they are identical.
If somebody wanted to see that themselves then I already told them what the...
The rest of that thread went extremely like the one on here!!!!
But the other one that did it and said it was fine was NOT doing it to RRs!!!
"Actually, on another forum someone said they had done this to three cars and it worked out great for...
So this is the person that knew a person:
"I know someone that did a similar thing, because he had a long daily commute. His only complaint was poor acceleration at higher speeds. However, he drove solo with no cargo.
If you use a roof rack, or...
Is the pump running for the washers? The strainers will often clog up and although it tries to operate it may well not actually be able to draw any fluid. If I were you, I'd try a test lamp on the connector for the pump before you go too far as...
Decided to brave the heat and strip it down. Question if I may...
I've got the clock cluster unplugged and out. Ign has been off for a couple of hours, is it safe to put the ign on to fiddle with the , now removed, blend motor? Or will the srs go...
So you've suddenly found 3 more cases of this?
Funny you didn't mention it before. :rolleyes:
Links please.
And if this really is the case, why don't you naff off and do some work/ get on with buying them and changing them/ find a life for...
The information here is available by searching previous articles.
Any new questions will be attacked for being stupid even when it is not.
So I will not waste my time asking any new questions here, but I still have access to all of the previous...
My daughter has a 2010 Discovery 4 HSE and there are some electrical issues that may be related. Specifically none of the washers work, but neither does the horn. I am not sure what else might have stopped working, but these two are important.
I...
Hi
I am wanting to replace the 3 seals on the FIP on my 97 p38.
I had a discussion with someone on here who posted a step by step guide but I can't find it for the life of me.
Can anyone help and guide me back to the link.
It's the 2 from the...
Just responding to dumb personal insults with laughs. I will continue to do this until it stops being funny. Each day I think I will get sick of doing it, but each day I find the new pathetic insults and gotcha questions still funny!
The glow plugs are new last year and about 1,000 miles ago. That’s not to say there couldn’t be an issue there. There’s about a third of a tank of fuel in it. I have a hand primer bulb fitted before the fuel filter, so I can confirm that the...
And I am OK laughing at these guys.
I am not laughing at you because you gave me valuable information.
I literally only glance at this forum for five minutes a few times a day, to see if those guys have finally shut up, or if they are still...