Latest activity

If you jack up both rear wheels they should spin fairly freely (in opposite directions). If not then the shoes might be too tight.

I've got a problem with my Td5 where my fuel gauge reads wrong and it all started when the fuel pump was out and I had a new one in but I've since gone back to my original pump yet the gauge still reads incorrectly, does anyone have any ideas 💡 🤔...

Morning All. :D The great day is here. Off to the Crem at 3pm and the ensuing wake till c. 9pm. :) I have promised there will be no fights (well not from me anyway). Have a great day. :D

im thinking about adding valves to open / close during summer/winter to avoid having to remove the dashboad. adding valves to the existing factory setup is very hard but i was thinking about using the blanked off hoses originally used for the egr...

How does it feel with engine off?

dont really understand how it works but i guess i did lol

Hi Try to bleed the clutch fluid first. If not better, change the master cylinder put one from Luk brand. If you are a yogi master is not that difficult, you should also know how to disconnect the master from the slave without the right tooling.

Should be the other way round getting a virus from a FL 😕

Two being built at presant but Havantthicket completion 2029 Lancaster 2040 !!!!!

not a fan of that size of jubilee clamp prefer the two wire type the jubilee clamps tend to distort the rubber hoses you can get smaller thinner jubilees that would fit better or the correct sized modern spring tensioned clamps ,be careful when...

So the whole drive train as noted in first post is not all Disco. Recon you just need the repair kit for axle of your year and fit new Railko bush and seal. You also need to set the swivel pre load for it to work right. How to info on the Youtube.

Actually I'm laughing at all of you guys every day given how wound up you all are about somebody asking a simple question. Just think about this, if no one commented to me with their gotcha questions I would've stopped posting here a long time...

Not retired, work for myself. I am from an age when swapping parts on a car was easy without computers. But I keep up with the times which is why I have an OBD reader and why I came here to ask questions about my planned change.

Test it, but indeed sound like you need to treat it to a shiny new battery

Sorry I replied to myself. The part cost 50 pounds and was not a land rover part. Is the master cylinder hard to fit if I get the original part.

I think it was a non land rover part. It cost around 50 pounds. Is it hard to change.

2011 Range Rover L322 blend door actuator not working properly. No cold air coming through on passenger side right side. Does anyone know the part number and where to get one other than a main dealer

I haven't checked them no, but they've been replaced with stainless steel ones from pioneer so I should imagine they are fine. The hand brake had been a little weird, it seems very... tight, when I drive with it off sometimes going over bumps...

Flexi will work for a while, mild steel flex short life span, stainless steel longer life span, but even they stiffen up and then split after time.

Hi everyone, I just joined the group and I need help with a problem. I bought a 2007 freelander2 2.2 with a broken timing chain which I replace the chain and the belt. The vehicle is turning but not starting and these permanent codes came up on...

E's got your teef.