New dog n bone up and running. Tinterweb,phone,messages all working. It is extremely smart, it has blanked out the freelander section all on its own. Sent from my noo wizzy toy.
Hello all. I have a freelander t d4 that is reluctant to go into reverse. As I look at the gear quadrant the rocking yolk is moving on the shaft and I’ve been told the roll pin will need replacing. ? My question is about the alignment of the...
Hi, I’m a newby here from Ireland, with a 2001 P38 2.5 diesel with 157,000 miles on it. I’ve found loads of useful info here and I’m hoping that someone might have an idea what’s going on with it before I give up on it. I’m not usually one to...
Last year I put vacuum on my Blue P38 AC system, but didn't get round to having it gassed. Re-checked to day & it still has full vacuum, so hopefully gonna get it done this week. Green P38 AC is nice & cold, so that one is getting used...
Try a number plate sale company.
Out of curiosity I enquired how much it would be to buy my own number. One company replied to say it was on their data base as 'For Sale'.
It wasn't me so possibly a previous owner ?
It's replacing a Samsung which is going senile. The S/S is quite old, about 9 years so no surprises. It was a hand-me down from "er indoors when she upgraded a couple of years ago. But it has stopped doing things - like not letting me sign into...
I reckon it's a 300tdi
We shall see if the chassis number exists with no welding in that area.
Maybe the OP can provide a photo of the chassis number stamped on the chassis.
Hi managed to get end of cill lower wheel arch out today, very rusty will make a new piece maybe in two pieces, but can now get to innercill to release and cut out rust so one more cut and it's going back together hopefully
Bit more...
The other next steps is a banch test like this: https://www.landyzone.co.uk/land-rover/97-p38-gems-eas-issue-which-seems-to-have-expanded.387706/post-5576496
Could it be the indicator stalk. The voltage that goes through it and tarnish on the joints fail. I had to do a similar check when main beam failed. Turned out to be a worn out stalk. Dunt the horn run through it?
Ok.. so I connected horn directly to battery.. all good, so horn is fine. Then I found the connector in the steering column, connected battery to here.. again horn is beeping so I’m assuming no break in wire. Then I did the same at the actual...
Just back from Kurrys with a noo krapple I-phone. Made my plastic squander card squeak. Will see if I can set it up this afternoon, without kidnapping a 9 year old kid.
hm, appreciate the way of thinking about the problem solving aspect.
I have the sump off still, so that would give me good acces to check the clearances of the skirts. More info soon. Thanks again.