It helps to know.
Does this refer to your
LR3 2008 V8 4.4 ???
If so @gstuart is your man so hopefully he'll jump on now he has been tagged.
Welcome to the forum!!!
As Tottot says follow the diagram above. If you can print it off it helps but if you keep a systematic approach ticking over in your head and start with the big boys, (battery/alternator/starter), use the masking tape or sharpie pen idea to track...
The carparthian is a very expensive defender edition, so I would say they are for the newer shape defender, hence why nobody on this poverty struck forum knows what they are!
The diesel struggles off road without low range to get up steep hills so the petrol will be worse.
For green laning or off road racing racing they are good but not so much for extreme off roading.
Wrong number of pulses would make the speedo wrong, plus front & rear wheel mismatch. ABS fault implies the sensor cannot see the reluctor.
Definitely. Supplier might have swapped them for P38 version if they were unused, but probably not...
I have a compressor. I still refuse to learn to spray it. Far too much risk of getting it wrong and messing the panel up. At least with a brush and roller if you get it wrong you can recover it by going over it again while Still wet!
Two year is...
Well done.
I don't think it's common for the original motors to fail but I can't comment on after market ones. I guess someone must have replaced the regulator and motor at the same time in the past.
I have to admit I usually order a repair kit...
Ok so here are your reading from the amounts in the bottles
1=25ml
2=12.5ml
3=20ml
4=35ml
If the test was done properly over a 2min period anything within the 20ml is acceptable.
As you can see 4 is the worst one so needs changing i would...
Someone's gone and woke me up, what is it?
Oh, nice Freelander, same colour as mine. If my gawjus leffer seats are ever nicked, I know who'll have done it.
I see there are a couple of old SWB G-Wagons listed on TradeMe at the mo that look in...
my plan is to use the P38 axels with brakes and suspension. then i will have to find out if i will use the RRC compressor and suspension ECU or if the L320 can do that better
I am not sure if the master cylinder and ABS setup from the P38 is...
Evening all eye is going to the shed as its miserable outdoors eye will be moving my tools to there noo home. :)
New hose fitted on the machine today an cutting superb after all my hardox welding, it will all need done again once ive got
all...
The only info I have is what the guy told me. He said : '' any edition, to secure stuff''
Im sorry if it is not so helpful. He had a defender 110 carpathian edition. could it be from that car?
If swivel pre load is out then thars your problem.
Note that the 3-4 kg pull recommended above is with the large ball housing seal removed.
It is just a trial and error job swapping shims until set right. Each time the pin bolts have to be...