Latest activity

That's a really smart idea. Well done. Thank you, also, for letting us know.

It's not just you

After disconnecting I got 24.9 volt

Condenser ???

Found the leak..

PEARLS OF WISD Clingfilm worked!

Most likely either the discs or pad set are the wrong part. Check the discs are the correct thickness ? If they are then the supplier is providing the wrong pad set.

Is it just me, or has the forum advert load just got insane recently? I mean, once I've slid up the drop down covering half the screen, I then get this kind of thing (screen shot from my phone) - It's madness. It's getting worse than...

I think I know what you’re referencing. It’s very possible that I’ve incorrectly fitted the clip on both sides as I watched a YouTube video on how to do it as well as my own intuition. I doubt the spindle would affect anything as the locking and...

Not my one, but was handy to use to find it!

Thanks, after quite a lot of searching finally found it! under layers of protection and dirt!

Hi everyone, you may remember me saying I purchased my first Series 2. Engine been sorted and now starting on the refurb, stripped completely . See pics below. My question is I want to spray paint it light green and have spent ages looking at...

Hi mate removed the back part of the passenger cill cover, managed to get cover self tappers out, Hands up was proved wrong, hole at bottom/back of cill, but they couldn't have known as you couldn't see, and I poked the hole, inside the cill...

The latch at the actual lock. The movement from pulling the door handle is transferred into lateral movement. The plastic clip I'm referring to joins two rods and allows movement through an angle. Though it has to be said if both sides not...

I expect the rat is scared of having your sausage inside him.

if you want a diesel reliable car look at p38 rather nthan a classic they are cheaer at the moment

Yeah - you’ve been turning them off every time !

I've been selecting reverse then pressing the switch :rolleyes: :rolleyes: Thanks I'll just leave it be in future 🙂

They should just activate when you engage reverse. Button just under the screen on the dash to turn off/on

Morning All. :D Still here (it seems). :) I was making some axles for a friend out of 15mm Silver Steel round bar yesterday. The end needed drilling and tapping at M8. Gosh that silver steel is tough. Very hard to cut the thread. Got to work...

Mornin Drizzle early on but brightening up Not be needing factor 50 in Scotland by the looks of it 🤔 Got me tools in the boot and a brolly, goin round to GF's to pick up her bags then see if there's any room left for mine 🤣 Should be heading...

Owned & run Land Rovers over many years, V8's / TDi's, thought I'd left them behind, 10 years on Jimny's, most recent a 21 plate Allgrip. I have just purchased a pretty down trodden Lightweight (Maybe it's a BDSM thing), I fitted five new tyres...

Simple things first. Disconnect the batteries, leaving only the cable between them. What voltage do you get across the two batteries?

I am facing this job. What modifications did you make?

Traps still set.

Morning all, I'm finally cracking on with getting my '87 110 sorted and have fitted a new (old) bulkhead and am fighting my way through the wiring with much re-splicing, broken switch replacement etc. and in general the parts are as usual all...

That'll do. That horizontal arm looks like it came out of a toilet cistern!

Progress made - with a couple of minor mods! Now to see if the seat cover goes on OK! Thanks for the replies...