I was pretty please with this!
I broke the Rear Ride Height Sensor on my 2004 D2 TD5. My fault. Overloaded a trailer briefly on a gravel road.
Anyway, after getting multiple comments about my saggy rear end, I made up this temp linkage...
Hi did you get anywhere with this fault
I have same fault
My driver's door electric window switches don't work and neither do mirror controls
So far checked fuses
Tried another switch
Tried another window module
The other windows all work...
I have something similar and works a treat
Think just the fact it’s been a bit since I cleaned it out I got overwhelmed 😡
Wish I had taken pictures first before I had a go
It’s not perfect but ok
My first plan would be do a leak back test, just chancing taking out al the injectors is work that may not be required, if the leak back test comes back within the allowed spec, then the next step would be to remove the HPFP regulator and change...
The females in my family seem to like to take a hold luggage sized bag/case each with us when we're going away for just a couple of nights. What with my toolbox and junk in the boot I struggle to fit their stuff in each time. I myself always...
Not much help to you I know, but this reminds me of every oil filter I've ever bought for the FL1 being supplied with a copper washer that does not fit the sump plug. I've got twelve of them now.
The problem is fuel delivery, I'm almost certain but I haven't inspected the car myself.
It needs to see if fuel is getting to the injectors or finding where it's getting too. The owner isn't mechanically inclined and I am too far away from him...
I had a big rat in a shed at work today and it was that busy it didn’t see me which was a mistake. Nipped out of the shed and fetched a 20 gauge, then went back into the shed and said bye to mr rat🫢
Sossij has bin put on one trap. Bit on trap and bit each side to tempt it frew either door hole. This time eye has also set the trap. Somefink eye fort eye'd done before but they may have triggered or eye fergot. Dun't fink so. First trap were...
The cable does not appear to be pulling correctly ? It's much easier to do with the assembly on the bench or table.
These screws should adjust the latch towards the front lid. There's a hole to access the screw heads for adjustment.
If...