Latest activity

How am I supposed to be lazy sitting upright? 😂

The ecu is standard to my knowledge but I haven’t opened it up to check the chip, I’ve played about with the timing and it seems best at around 6-8deg btdc. Plugs are standard Ngk BP6ES

Yer butt no butt 🤣 🤣

sorry but🤷😅

Just sit upright 🤷😜

What plugs are you running compared to standard?

If it's programmed, does the original timing need to be adjusted as well. 6-10°btd?

In reference to what my mate? 😉

We has been watching Silent Witness vids. DVDs bought online. With Dutch subtitles. Only fing is, more an more of them have problems playing to the end. I take them out, I clean them but still we don't get to the very end of the story. Rather a...

Was kind of hoping that a smoke test would find something simple like that but no the hoses are fine. I’ve checked them individually as well. Also got hold of another ecu to compare and still have the same rough idle although not taken it out on...

You might I couldn't possibly comment. Not being that well aquainted with Cat's rear ends!!! 🤣🤣🤣

I have to be honest, I am not 100% sure, but I think the peteroil from Stihl had a colour before he added the oil.

I usually ask ChatGPT, you don't have to listen but it often raises points I hadn't thought about. It's RHD actually, I was going to put it in with the fuses since there's lots of electricity and lots of space (TD5). I'd looked at the waterproof...

Reminds me of what the "shepherds" wore in the nativity plays!.🤣

I have enough to make a pigtail. Just cos I is bald in the middle.... 🤣 🤣 🤣

I have 6 grand kids.

I can recommend the Haynes manuals as a start point if you prefer to read. The actual factory manuals can also be found in line and from booksellers. Britannia restorations, Mike, from Canada, on YouTube, is excellent.

Might have to wait and order another, Knocked it in tonight went in quite easy but left it flush, now that I have looked at more vids when I got back I think it should be tapped in all the way down. Probably settled where it is now, when I try...

Under the drivers knee panel red connector mine kept blowing the resistor

So, running rich.. An open vacuum line or split in a air pipe somewhere 🤔

From the air intake in the plenum with the butterfly open

Thanks for this. I tested the relay on the bench, as you suggested. Seemed to work well (ie, activated the higher amp circuit), but not in the vehicle. Swapped another relay in and it worked. Either the original relay is unreliable or...

i hope this is a bingo, the setting was not enabled. will have a go tomorrow and report. thanks for now

no exhaust leaks never had time to swap sensors london most of day with ill mother in law got some more data

Did the school run it it today. It failed to start after the pickup. A wiggle of the starter wiring and she was away!

Ive seen this but it's a million dollars from America and the L322 side anchor points would need some serious beefing up somehow. I also suspect this is too tall to fit the anchor points.

Stealing from a funeral directors now that's a bit deep init. :oops:

Front & rear are totally different shapes the U shape one goes to the rear. I chucked 2 sets away as I fitted 4 link kits. My other disco was lifted & I made 50mm lowering blocks out of box section to stop the rear one from flipping. Got pics...

Word of caution. Please make sure that any advice sought id placed in the Freelander section. Do not put such queries in the "Anything Goes" section. Many on there believe that Freelanders are the preferred vehicles of moffies. There is a...

Double cab iveco pickups round here. They were nicking from the co-op last week and the number plate on the pickup was false 🤔