Latest activity

Well at least others may benefit from your info.

It ain't arf ot mum..

Plastik breaks down over time, tickly wif heat. Tratter up and buy some new mugs mebbe. You've already spent enough buggrin about already..

We who is nortical calls it a queue. Besides you is follickly challenged intcha.

Now how do you know that 😮😮😮😮😮

Errr, yes... Dont know that couple from yorkshire do you 🤔😜

Tea towel with a elastic band keeps the Sun of your neck as a bonus 😉

Fantastic, thanks for the info. Apart from poor fuel economy and general inefficiency, is there any reason to do the APC urgently? If not, I’ll just ask them to do this during its next service, rather than pay to have it done separately.

Yes Sat night camping is the plan. That's not to say Friday night is a no no if you have far to come.

Be careful not to contaminate running surface if you add sealer [ original seal had a sealer already on the outside] Locating seal in housing can be done by careful tapping around the seal if seal fitting tool not available. One chap on here...

Do forests count?

One would assume the correct side, on the right lol.

Not seen the exhaust so was trying to think outside the box. Sorry

So. If you suck and then put your tongue over the hole to hold vacuum, does it hold or drop back?

Hi it’s running non cat map and no lambada it’s Hotwire maf setup. I have sucked on the advance pipe and I can see it advancing with a timing light.

surely that would not work because the join is well before the centre box.

I might be in Reading next week, but don't know what day yet. If you're nearby I can bring my Nanocom.

Nanocom also shows BECM inputs including the window switches. That together with the ability to activate outputs to test the windows & locks means you can nail down where the fault is.

I'd do a leak off test on the Injectors, I've a client with the 2.4 duratorq lump. Rough idle and four injectors later it's fine. There is an issue we're a bad injector can ruin the block. There are a lot of folks reverting back to the later...

I thought it was all Ford until you got to the transfer box being landrover, hence the gearbox extension casing and silly output shaft that rips teeth for a living? 🤔

Hi, Yes galvanised chassis. Also overdrive and lwb front axle with twin cylinders. Not too worried about colour, certainly wasn't going to not purchase because of the colour, except maybe if had been pink. Also has new parabolics and shocks and...

Is it an airflow meter or the air flap setup?

It sounds like the vacuum bell has rotted on the side of the dizzy. This will stop dizzy timing adjusting🤔 Does it have exhaust lambda sensors on it? Not familiar with this era but.... 👍

Hi, You should always put quality driveshaft. Don't forget that is a 4x4 with heavy angles, so aftermarket ones are designed to fit the car, not to comply to all constrains. If you can't find one, put a preowned one, you can renew the gaiters...

Looks nice up top, not so sure about the colour and the roof colour though. Has it got a galvanised chassis ? Heres a link to a rebuild thread ... https://www.landyzone.co.uk/land-rover/200tdi-s3-88-pas-long-travel-suspension-rebuild.298104/...

Just find all the srs plugs and hard wire them anyway. Have a client with a 2000 38'. Serious water ingress in the past. We just took all the connectors out for the srs system. Put an end to that issue. Check the bulbs and replace all of them...