andyfox2005
Active Member
- Posts
- 464
Would the outer wings and bonnet fron a discovery 2 fit on a discovery 1
Would d2 wings and bonnet fit a d1
- Thread starter andyfox2005
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
phil540uk
Active Member
- Posts
- 390
- Location
- Preston, Lancashire
Not sure if they will physically fit, but even if the wings do fit they would look odd against disco 1 doors as the swage lines are different.
MGBGTV8
Active Member
- Posts
- 690
- Location
- Alfreton, Derbyshire
Wings, doors and rear wings / quarter panels definitely fit. There was a D1 / D2 hybrid up for sale on here recently that caused a fair bit of discussion. Metalic red IIRC.
Bonnet... er... if I were a betting man I'd go for a "no" given the D2 is wider than the D1.
Bonnet... er... if I were a betting man I'd go for a "no" given the D2 is wider than the D1.
phil540uk
Active Member
- Posts
- 390
- Location
- Preston, Lancashire
Can't see the rear quarters fitting straight on, the disco 2 has a longer back end than the disco 1 so they must have been fettled to fit.
I didn't realise the d2 was wider?
I didn't realise the d2 was wider?
cruiser524
New Member
- Posts
- 235
- Location
- manchester
no mate they wont
andyfox2005
Active Member
- Posts
- 464
Only wanted to know because i did a head light upgrade and my cutting skills are to be desired and the d2 wings already have the cut out for my headlights
MGBGTV8
Active Member
- Posts
- 690
- Location
- Alfreton, Derbyshire
Must have been d2 quarters on d1 wings, then!
henseyseries3
Active Member
- Posts
- 191
- Location
- Birmingham Kingsnorton
You have to cut the the rear quarters where the lights go and trim the d2 quarters so they fit over
If my dad don't take his disco to work tomorrow I'll try and get a better picture
If my dad don't take his disco to work tomorrow I'll try and get a better picture
andyfox2005
Active Member
- Posts
- 464
I see hes used checker plate to cover the gap or join ?
henseyseries3
Active Member
- Posts
- 191
- Location
- Birmingham Kingsnorton
Its just so you can't see the counter sunk pot riverts
andyfox2005
Active Member
- Posts
- 464
Try getting more pics if you can
henseyseries3
Active Member
- Posts
- 191
- Location
- Birmingham Kingsnorton
Will do I'll try and find some old ones out from when we put them on
andyfox2005
Active Member
- Posts
- 464
Nice one
henseyseries3
Active Member
- Posts
- 191
- Location
- Birmingham Kingsnorton
andyfox2005
Active Member
- Posts
- 464
Id love to see under the plate
henseyseries3
Active Member
- Posts
- 191
- Location
- Birmingham Kingsnorton
andyfox2005
Active Member
- Posts
- 464
Why did he put the plate on it looks ok
sidewaysste
Active Member
- Posts
- 715
- Location
- Nottingham
Have you got any more pics of the roll cage?
henseyseries3
Active Member
- Posts
- 191
- Location
- Birmingham Kingsnorton
I don't know I think it was just one of then things that we just did
henseyseries3
Active Member
- Posts
- 191
- Location
- Birmingham Kingsnorton
