wiring

G-man · Mar 1, 2009

i have got the othe point where i am not sure what too do!!!!!

I am contemplating re-wiring the whole of the lighting system on my series 3 i have already done the rear end and run new cable to the front but taking the fuse box out has left me in a quandry its a mess behind there lots of same colour wires (greens and browns) and everthing goes to 35a fuses

so i already have a 10gang fuse board in my toolbox

do i re-wire to the existing fuses or fit the new fuse box and make a new wiring system???

90truckcab · Mar 1, 2009

well am gona do the whole series when i get to it, just trace exactly what yer need, not nesesairly using the wiring diagram , and take yer time with it, thers prob loas o **** connected that yer dont need

brnocz · Mar 1, 2009

Gman are you rewiring from a mass of wires with out a diagram 2 tools you need 1volt meter/tester no/2 12/24volt probe, the probe is worth its cost and a wiring diagram

G-man · Mar 1, 2009

1 i have a good multi meter 2 i cant be ****ed doing it so i am gonna put attach my new rear wiring to the switches etc as i don't have time to do a complete re-wire

doobie · Mar 1, 2009

i'd recommend just sorting the system you need, cutting out some of the obviously redundant/weird ****e and leaving it at that. once you've boxed up the dash you'll have forgotten about the mess underneath, unless you've got OCD......

i believe the saying "opening up a can of worms" was originally derived from "opening up a series 3's dash" but the wording was changed by those of the none landy persuasions for more general everyday use.

brnocz · Mar 1, 2009

when i rewired my ser 111 i chopped off the wires for the back end where they go into the chassis under the footwell but left enough cable to run it back to behind the drivers seat, i then fitted a rubberlite junction box where i then used 7core wire from the box and ran it down under the tub in a plastic cable protector to the rear end the spare wires were left in the cable to be used for work lights ect,

CharlesY · Mar 1, 2009

doobie said:
i'd recommend just sorting the system you need, cutting out some of the obviously redundant/weird ****e and leaving it at that. once you've boxed up the dash you'll have forgotten about the mess underneath, unless you've got OCD......

i believe the saying "opening up a can of worms" was originally derived from "opening up a series 3's dash" but the wording was changed by those of the none landy persuasions for more general everyday use.

WORMS ..... acronym ....

Wiring Obscure Reasons Mass of Spaghetti

wiring

G-man

BBQ king

90truckcab

Well-Known Member

brnocz

New Member

G-man

BBQ king

doobie

Active Member

brnocz

New Member

CharlesY

Well-Known Member

Similar threads