What have you done to your Landie today.

A frame ball joint took best part of 7 tons to shift the ****ing thing heat and penetrating fluid did nothing

i gotta do mine at some point.... i'm thinking a dirty gert hammer and beat it out

cut the lugs off mine warmed and lubed it up and pressed it out.

what one have you fitted adjustable?

G-man said:

what one have you fitted adjustable?

Click to expand...

one I removed was adjustable, full of **** and totally ****ed.
think it's a Bearmach or all makes one.
Not adjustable

so its a lockheed one you fitted?

pass came in sealed plastic packet and I didn't pay for it

Looked better than ****part-but who knows

most likely all makes or summat they like plastic packs

changed the passenger window regulator - then banged me shin on the tow hitch
bastard
bastard
bastard
bloody great lump on me shin now, I dont think my disco likes me, every time I work on it I bang, cut or graze some part of me anatomy

today i removed all the wiring from the bulkhead with a pair of side cutters
my little bro removed the vac tank from the inner wing, and i found that even when a chassis has been stored in a dry garage most of its life the bolts that hold the rear lashing eyes on will still be seized and refuse to come out currently being soaked in wd40 in the hope they will come out tomorrow

trax99 said:

changed the passenger window regulator - then banged me shin on the tow hitch
bastard
bastard
bastard
bloody great lump on me shin now, I dont think my disco likes me, every time I work on it I bang, cut or graze some part of me anatomy

Click to expand...

hope you didn't get a britpart one, i did one for a customer using a britpart one and it dropped the window when the welds snapped

Sunday fitted new set of swivell bearings and seal on me 110. Hopefully the clunking will have stopped now.
Today I fitted new trackrods and ends and welded up me outrigger. Then stripped me steering guard for a repaint. Gave me bumper a rub down and a coat of red oxide as it was looking in a sorry state after its trip through the spanish salt mines. Going out now to give it a sand and a coat of shiny black. MOT is due and tax is up the end of the month so best get it done soon.

Ive put 10 quids worth of petrol in it cos ive gotta drive round the block tommorrow.

fitted noo UJ and fitted the prop back on and..................drove it out of my drive about 12ft got frightened and put her back on the drive !

Wavey said:

Ive put 10 quids worth of petrol in it cos ive gotta drive round the block tommorrow.

Click to expand...

snigger

nathan5346 said:

snigger

Click to expand...

I used a Jerry Can aswell cos i didnt wanna waste any of that tenner driving back from the petrol station!

Have painted me bumper and seam sealed the footwell on the series 2

picked the landy up from its mot, needed a number plate light bulb a foglight bulb a hazard warning switch and a front wheel bearing. not bad for a 20 year old landy that aint turned a wheel in a year and a half. Do a service when i got time, tidy it up a bit then sell it

fitted a pair of side steps and a steering guard this afternoon and added some nice holes into my hand after one of the rusty old 17mm bolts snapped

picked up chassis & diff...oooh its excitin!